USB3329C-GL-TR Datasheet, PDF (79/79 Pages) Microchip Technology – Industry’s Smallest Hi-Speed USB Transceiver with 1.8V ULPI Interface

REVISION LEVEL
AND DATE
Rev. 1.0
(08-26-08)
Rev. 1.0
(08-26-08)
Rev. 1.0
(08-26-08)
Rev. 1.0
(08-26-08)
Rev. 0.5
(07-23-08)
Rev. 0.5
(07-08-08)
Rev. 0.5
(07-08-08)
Rev. 0.5
(07-08-08)
Rev. 0.4
(06-25-08)
Rev. 0.4
(04-08-08)
Industry’s Smallest Hi-Speed USB Transceiver with 1.8V ULPI Interface
Table 10.1 Customer Revision History (continued)
Datasheet
SECTION/FIGURE/ENTRY
CORRECTION
Section 8.2.2, “Detecting DP
Shorted to DM”
Changed: “Enable ChargerPullupEnableDP resistor”
to: “Enable ChargerPullupEnableDM resistor”
Table 7.1, "ULPI Register Map"
Table 5.2, "Operating Mode vs.
Power Supply Configuration"
Table 3.2, "Recommended
Operating Conditions"
Reserved register for 00h, address changed from
“22-35h” to “22-30h”
Added “Reserved” row 32-35h across
Removed from table following “RESET Mode”:
“VDD18 Current <1uA”
removed from note following table: “This column
assumes the VBAT pin is powered as described
above.”
added: “. . .per Table 3.2”
Removed “CPEN” from “Voltage on Analog I/O Pins”
(Parameter column)
Section 5.2.1, "USB
Transceiver"
Added paragraph describing boost bit operation.
Section Table 4.2, "ULPI Clock Added MIN value for T_PREP and corrected MAX
Specifications"
value.
Section 7.1.3.1, "HS TX Boost" Boost Register added to support configuration of
drive strength increase.
Section 7.1.1.10, "USB Interrupt Correct ACCESS to remove the auto-clear notation.
Status"
Table 4.1, "Operating Current"
Table values updated; conditions above table
modified
Section 8.2.1 “Detecting the ID Pseudo Algorithm for detecting resistor to ground
Resistor in a Charger”
and reading value modified
SMSC USB332x
79
DATASHEET
Revision 1.1 (11-20-12)