PIC10F220_1 Datasheet, PDF (55/86 Pages) Microchip Technology – High-Performance Microcontrollers with 8-bit A/D

PIC10F220/222
10.1 DC Characteristics: PIC10F220/222 (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise specified)
Operating Temperature -40×C ≤ TA ≤ +85°C (industrial)
Param
No.
Sym
Characteristic
Min Typ⁽¹⁾ Max Units
Conditions
D001
D002
VDD Supply Voltage
VDR RAM Data Retention Voltage⁽²⁾
2.0
5.5
V See Figure 10-1
1.5* —
—
V Device in Sleep mode
D003
VPOR VDD Start Voltage
to ensure Power-on Reset
— Vss —
V
D004
SVDD
IDD
VDD Rise Rate
to ensure Power-on Reset
Supply Current⁽³⁾
0.05* —
— V/ms
D010
IPD Power-down Current⁽⁴⁾
— 175 275 μA VDD = 2.0V, Fosc = 4 MHz
— 0.625 1.1 mA VDD = 5.0V, Fosc = 4 MHz
— 250 400 μA VDD = 2.0V, Fosc = 8 MHz
— 0.800 1.5 _mA VDD = 5.0V, Fosc = 8 MHz
D020
IWDT WDT Current⁽⁴⁾
—
0.1
1.2
μA VDD = 2.0V
—
1
2.4 μA VDD = 5.0V
D022
— 1.0
3
μA VDD = 2.0V
—
7
16 μA VDD = 5.0V
*
Note 1:
2:
3:
4:
These parameters are characterized but not tested.
Data in the Typical (“Typ”) column is based on characterization results at 25°C. This data is for design guidance only
and is not tested.
This is the limit to which VDD can be lowered in Sleep mode without losing RAM data.
The supply current is mainly a function of the operating voltage and frequency. Other factors such as bus loading, bus
rate, internal code execution pattern and temperature also have an impact on the current consumption.
a) The test conditions for all IDD measurements in active operation mode are:
All I/O pins tri-stated, pulled to VSS, T0CKI = VDD, MCLR = VDD; WDT enabled/disabled as specified.
b) For standby current measurements, the conditions are the same, except that the device is in Sleep mode.
Power-down current is measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD
or VSS. The peripheral current is the sum of the base IPD and the additional current consumed when the peripheral is
enabled.
© 2007 Microchip Technology Inc.
DS41270E-page 53