51795B Datasheet, PDF (52/100 Pages) Microchip Technology – PICkit™ 3 Programmer/Debugger

PICkit™ 3 User’s Guide
See Section 9.3.2 “Debugger-to-Target Communication Error Actions”.
PK3Err0047: Bootloader download failed.
See Section 9.3.3 “Debugger-to-PC Communication Error Actions”.
PK3Err0052: The current PICkit 3 hardware version %x, is out of date. This
version of MPLAB IDE will support only version %x or higher.
Did you click Cancel when asked to download the latest firmware? If so, you will
need to download it now. Select Debugger>Settings, Configuration tab, and
click Manual Download. Select the highest number .jam file and click Open.
If you cannot find any files to download or if this does not work (corrupted file),
you will need to get the latest version of MPLAB IDE and install it. Find the latest
MPLAB IDE at www.microchip.com.
PK3Err0053: Unable to get PICkit 3 protocol versions.
See Section 9.3.3 “Debugger-to-PC Communication Error Actions”.
PK3Err0054: MPLAB IDE's PICkit 3 protocol definitions are out of date. You must
upgrade MPLAB IDE to continue.
Find the latest MPLAB IDE at www.microchip.com.
PK3Err0055: Unable to set firmware suite version.
PK3Err0056: Unable to get voltages from PICkit 3.
See Section 9.3.3 “Debugger-to-PC Communication Error Actions”.
PK3Err0068: Failed while writing to boot Flash memory.
PK3Err0069: Failed while reading boot Flash memory.
PK3Err0070: Failed while writing peripheral memory.
PK3Err0071: Failed while reading peripheral memory.
See Section 9.3.1 “Read/Write Error Actions”.
PK3Err0072: Unable to send freeze peripheral information.
PK3Err0073: Device is code-protected.
The device on which you are attempting to operate (read, program, blank check
or verify) is code-protected, i.e., the code cannot be read or modified. Check your
Configuration bits setting for code protection.
To disable code protection, set or clear the appropriate Configuration bits in code
or in the Configuration Bits window (Configure>Configuration Bits), according to
the device data sheet. Then erase and reprogram the entire device.
PK3Err0075: Unable to set power.
PICkit 3 cannot supply power to the target.
PK3Err0080: Failed setting shadow bit(s).
9.3 GENERAL CORRECTIVE ACTIONS
These general corrective actions may solve your problem:
• Read/Write Error Actions
• Debugger-to-Target Communication Error Actions
• Debugger-to-PC Communication Error Actions
• Corrupted Installation Actions
• USB Port Communication Error Actions
• Debug Failure Actions
• Internal Error Actions
DS51795B-page 52
 2010 Microchip Technology Inc.