MCP1525_13 Datasheet, PDF (3/20 Pages) Microchip Technology – 2.5V and 4.096V Voltage References

MCP1525/41
AC ELECTRICAL SPECIFICATIONS
Electrical Characteristics: Unless otherwise indicated, T_A = +25°C, V_IN = 5.0V, V_SS = GND, I_OUT = 0 mA and C_L = 1 µF.
Parameter
Sym Min Typ Max Units
Conditions
AC Response
Bandwidth
BW
—
100
—
kHz
Input and Load Capacitors (see Figure 4-1)
Input Capacitor
Load Capacitor
Noise
C_IN
—
0.1
—
µF Notes 1
C_L
1
—
10
µF Notes 2
MCP1525 Output Noise Voltage
E_no
—
90
—
µV_P-P 0.1 Hz to 10 Hz
E_no
—
500
—
µV_P-P 10 Hz to 10 kHz
MCP1541 Output Noise Voltage
E_no
—
145
—
µV_P-P 0.1 Hz to 10 Hz
E_no
—
700
—
µV_P-P 10 Hz to 10 kHz
Note 1: The input capacitor is optional; Microchip recommends using a ceramic capacitor.
2: These parts are tested at both 1 µF and 10 µF to ensure proper operation over this range of load capacitors. A wider
range of load capacitor values has been characterized successfully, but is not tested in production.
TEMPERATURE SPECIFICATIONS
Electrical Characteristics: Unless otherwise indicated, T_A = +25°C, V_IN = 5.0V and V_SS = GND.
Parameter
Sym Min Typ Max Units
Conditions
Temperature Ranges
Specified Temperature Range
Operating Temperature Range
Storage Temperature Range
Thermal Package Resistances
T_A
-40
—
+85
°C
T_A
-40
—
+125
°C Note 1
T_A
-65
—
+150
°C
Thermal Resistance, TO-92
_JA
—
132
—
°C/W
Thermal Resistance, SOT-23-3
_JA
—
336
—
°C/W
Note 1: These voltage references operate over the Operating Temperature Range, but with reduced performance. In any case,
the internal Junction Temperature (T_J) must not exceed the Absolute Maximum specification of +150°C.
1.1 Specification Descriptions and
Test Circuits
1.1.1 OUTPUT VOLTAGE
Output voltage is the reference voltage that is available
on the output pin (V_OUT).
1.1.2 INPUT VOLTAGE
The input (operating) voltage is the range of voltage
that can be applied to the V_IN pin and still have the
device produce the designated output voltage on the
V_OUT pin.
1.1.3
OUTPUT VOLTAGE DRIFT (TCV_OUT)
The output temperature coefficient or voltage drift is a
measure of how much the output voltage (V_OUT) will
vary from its initial value with changes in ambient
temperature. The value specified in the electrical
specifications is measured and equal to:
EQUATION 1-1:
TCV_OUT = ^-----^V---^O----^U--_--^T--_T--^-_A--^V---^N----^O----^M--
Where:
ppm  C
V_NOM = 2.5V, MCP1525
V_NOM = 4.096V, MCP1541
 2001-2012 Microchip Technology Inc.
DS21653C-page 3