AC162061 Datasheet, PDF (3/12 Pages) Microchip Technology – Header Specification

Header Specification
HEADERS FOR ICE DEVICES
Devices that have built-in debug circuitry do not require a header to use MPLAB ICD 2.
However, some pins and memory must be used to support the ICD function. Special
ICE versions offering additional pins, memory and emulator functions can be used to
provide superior debugging capabilities.
Currently-available headers and their associated ICE devices/supported devices are
shown in Table 2.
TABLE 2: HEADER TYPES – ICE DEVICES
Header Part Number
ICE Device Used
Devices Supported
VDD
Max
64/80 Pin AC162062 PIC18F87J10-ICE
PIC18F65J10/85J10
3.6
PIC18F65J15/85J15
PIC18F66J10/86J10
PIC18F66J15/86J15
PIC18F67J10/87J10
INSTALLATION
The MPLAB ICD 2 header is installed by following these steps:
1. Set up the header board.
2. Connect the header and MPLAB ICD 2.
3. Connect the header and the target board.
Set Up the Header Board
To set up a header board:
1. If the ICD device is not soldered onto the header, plug the ICD device into the
socket on the top of the header.
2. Set any jumpers or switches to determine device functionality/selection as
specified in the following sections.
8/14-PIN HEADERS
For some headers, device peripherals need to be selected by setting jumper J1 to the
appropriate position. This will have the effect of selecting the device.
Device
PIC12F629
PIC12F675
PIC16F630
PIC16F676
PIC12F635
PIC16F636
Jumper Setting
2-3
1-2
2-3
1-2
2-3
1-2
Peripheral Function
A/D Disabled
A/D Enabled
A/D Disabled
A/D Enabled
PORTC, Comparator 2 Disabled
PORTC, Comparator 2 Enabled
© 2005 Microchip Technology Inc.
DS51292L-page 3