DSPIC30F3011-30I Datasheet, PDF (215/226 Pages) Microchip Technology – High-Performance, 16-Bit Digital Signal Controllers

APPENDIX A: REVISION HISTORY
Revision B (May 2006)
Previous versions of this data sheet contained
Advance or Preliminary Information. They were
distributed with incomplete characterization data.
This revision reflects these updates:
• Supported I²C Slave Addresses
(see Table 17-1)
• ADC Conversion Clock selection to allow 1 Msps
operation (see Section 19.0 “10-bit High-Speed
Analog-to-Digital Converter (ADC) Module”)
• Operating Current (IDD) Specifications
(see Table 23-5)
• Power-Down Current (IPD)
(see Table 23-7)
• I/O pin Input Specifications
(see Table 23-8)
• BOR voltage limits
(see Table 23-10)
• Watchdog Timer time-out limits
(see Table 23-20)
Revision C (September 2006)
Updates made to Section 23.0
Characteristics”.
“Electrical
Revision D (January 2007)
This revision includes updates to the packaging
diagrams.
dsPIC30F3010/3011
Revision E (April 2008)
This revision reflects these updates:
• Added OSCTUN register information and updated
the OSCCON register information (removed TUN
bits) in System Integration Register Map (see
Table 20-7)
• Changed the location of the input reference in the
10-Bit High-Speed ADC Functional Block
Diagram (see Figure 19-1)
• Added Fuse Configuration Register (FICD) details
(see Section 20.6 “Device Configuration
Registers” and Table 20-8)
• Added Note 2 in Device Configuration Registers
table (Table 20-8)
• Updated FOSC register bit definition in Device
Configuration Registers table (Table 20-8)
• Electrical Specifications:
- Updated values for parameters DO10, DO16,
DO20, and DO26 (see Table 23-9)
- 10-Bit High-Speed ADC tPDU timing parame-
ter (time to stabilize) has been updated from
20 µs typical to 20 µs maximum (see
Table 23-39)
- Parameter OS65 (Internal RC Accuracy) has
been expanded to reflect multiple Min and
Max values for different temperatures (see
Table 23-18)
- Parameter DC12 (RAM Data Retention Volt-
age) has been updated to include a Min value
(see Table 23-4)
- Parameter D134 (Erase/Write Cycle Time)
has been updated to include Min and Max
values and the Typ value has been removed
(see Table 23-11)
- Removed parameters OS62 (Internal FRC
Jitter) and OS64 (Internal FRC Drift) and
Note 2 from AC Characteristics (see
Table 23-17)
- Parameter OS63 (Internal FRC Accuracy)
has been expanded to reflect multiple Min
and Max values for different temperatures
(see Table 23-17)
- Updated Min and Max values and Conditions
for parameter SY11 and updated Min, Typ,
and Max values and Conditions for
parameter SY20 (see Table 23-20)
• Additional minor corrections throughout the
document
© 2008 Microchip Technology Inc.
DS70141E-page 213