24C01C_07 Datasheet, PDF (2/24 Pages) Microchip Technology – 1K 5.0V I2C ™ Serial EEPROM

24C01C
1.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings^(†)
VCC.............................................................................................................................................................................7.0V
All inputs and outputs w.r.t. VSS ......................................................................................................... -0.6V to VCC +1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied ................................................................................................-40°C to +125°C
ESD protection on all pins ......................................................................................................................................................≥ 4 kV
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to
the device. This is a stress rating only and functional operation of the device at those or any other conditions
above those indicated in the operational listings of this specification is not implied. Exposure to maximum rating
conditions for extended periods may affect device reliability.
TABLE 1-1: DC CHARACTERISTICS
All parameters apply across the
specified operating ranges unless
otherwise noted.
VCC = +4.5V to +5.5V
Industrial (I):
Automotive (E):
TA = -40°C to +85°C
TA = -40°C to +125°C
Parameter
Symbol
Min.
Max. Units
Conditions
SCL and SDA pins:
High-level input voltage
Low-level input voltage
Hysteresis of Schmitt Trigger
inputs
Low-level output voltage
Input leakage current
Output leakage current
Pin capacitance (all inputs/outputs)
VIH
VIL
VHYS
0.7 VCC
0.05 VCC
VOL
ILI
—
ILO
—
CIN, COUT
—
—
.3 VCC
—
.40
±1
±1
10
Operating current
Standby current
ICC Read
—
1
ICC Write
—
3
ICCS
—
50
Note: This parameter is periodically sampled and not 100% tested.
V
V
V (Note)
V IOL = 3.0 mA, VCC = 4.5V
μA VIN = VSS or VCC, WP = Vss
μA VOUT = VSS or VCC
pF VCC = 5.0V (Note)
TA = 25°C, f = 1 MHz
mA VCC = 5.5V, SCL = 400 kHz
mA VCC = 5.5V
μA VCC = 5.5V, SDA = SCL = VCC
WP = VSS
DS21201G-page 2
© 2007 Microchip Technology Inc.