PIC16C62B Datasheet, PDF (14/120 Pages) Microchip Technology – 28-Pin 8-Bit CMOS Microcontrollers

PIC16C62B/72A
2.2.2.4 PIE1 REGISTER
This register contains the individual enable bits for the
peripheral interrupts.
REGISTER 2-4: PIE1 REGISTER (ADDRESS 8Ch)
Note: Bit PEIE (INTCON<6>) must be set to
enable any peripheral interrupt.
U-0
R/W-0
U-0
—
ADIE⁽¹⁾
—
bit7
U-0
R/W-0 R/W-0 R/W-0
—
SSPIE CCP1IE TMR2IE
bit 7:
bit 6:
Unimplemented: Read as ‘0’
ADIE⁽¹⁾: A/D Converter Interrupt Enable bit
1 = Enables the A/D interrupt
0 = Disables the A/D interrupt
bit 5-4: Unimplemented: Read as ‘0’
bit 3:
SSPIE: Synchronous Serial Port Interrupt Enable bit
1 = Enables the SSP interrupt
0 = Disables the SSP interrupt
bit 2:
CCP1IE: CCP1 Interrupt Enable bit
1 = Enables the CCP1 interrupt
0 = Disables the CCP1 interrupt
bit 1:
TMR2IE: TMR2 to PR2 Match Interrupt Enable bit
1 = Enables the TMR2 to PR2 match interrupt
0 = Disables the TMR2 to PR2 match interrupt
bit 0:
TMR1IE: TMR1 Overflow Interrupt Enable bit
1 = Enables the TMR1 overflow interrupt
0 = Disables the TMR1 overflow interrupt
R/W-0
TMR1IE
bit0
R = Readable bit
W = Writable bit
U = Unimplemented bit,
read as ‘0’
- n = Value at POR reset
Note 1: The PIC16C62B does not have an A/D module. This bit location is reserved on these devices. Always maintain this
bit clear.
DS35008B-page 14
Preliminary
© 1999 Microchip Technology Inc.