24AA16H Datasheet, PDF (11/28 Pages) Microchip Technology – 16K I2C™ Serial EEPROM with Half-Array Write-Protect

24AA16H/24LC16BH
8.0 PIN DESCRIPTIONS
The descriptions of the pins are listed in Table 8-1.
TABLE 8-1: PIN FUNCTION TABLE
Name
A0
A1
A2
VSS
SDA
SCL
WP
VCC
PDIP
1
2
3
4
5
6
7
8
SOIC
1
2
3
4
5
6
7
8
TSSOP
1
2
3
4
5
6
7
8
TDFN
1
2
3
4
5
6
7
8
MSOP
1
2
3
4
5
6
7
8
SOT-23
—
—
—
2
3
1
5
4
Description
Not Connected
Not Connected
Not Connected
Ground
Serial Address/Data I/O
Serial Clock
Write-Protect Input
+1.7V to 5.5V Power Supply
8.1 Serial Address/Data Input/Output
(SDA)
SDA is a bidirectional pin used to transfer addresses
and data into and out of the device. Since it is an open-
drain terminal, the SDA bus requires a pull-up resistor
to VCC (typical 10 kΩ for 100 kHz, 2 kΩ for 400 kHz).
For normal data transfer, SDA is allowed to change
only during SCL low. Changes during SCL high are
reserved for indicating Start and Stop conditions.
8.2 Serial Clock (SCL)
The SCL input is used to synchronize the data transfer
to and from the device.
8.3 Write-Protect (WP)
The WP pin must be connected to either VSS or VCC.
If tied to VSS, normal memory operation is enabled
(read/write the entire memory 000h-7FFh).
If tied to VCC, write operations are inhibited, half of the
memory will be write-protected (400h-7FFh). Read
operations are not affected.
8.4 A0, A1, A2
The A0, A1 and A2 pins are not used by the 24XX16H.
They may be left floating or tied to either VSS or VCC.
© 2008 Microchip Technology Inc.
DS22118A-page 11