|
USB3370 Datasheet, PDF (1/75 Pages) Microchip Technology – Enhanced Single Supply Hi-Speed USB ULPI Transceiver | |||
|
USB3370
Enhanced Single Supply Hi-Speed USB ULPI Transceiver
Highlights
⢠USB-IF Battery Charging 1.1 Specification Com-
pliant
⢠Link Power Management (LPM) Specification
Compliant
⢠Integrated ESD protection circuits
- Up to ±25kV IEC Air Discharge without exter-
nal devices
⢠Over-Voltage Protection circuit (OVP) protects the
VBUS pin from continuous DC voltages up to 30V
⢠Microchip RapidCharge Anywhere⢠Provides:
- 3-times the charging current through a USB
port over traditional solutions
- USB-IF Battery Charging 1.1 compliance to
any portable device
- Charging current up to 1.5Amps via compati-
ble USB host or dedicated charger
- Dedicated Charging Port (DCP), Charging
(CDP) & Standard (SDP) Downstream Port
support
⢠flexPWR® Technology
- Extremely low current design ideal for battery
powered applications
- âSleepâ mode tri-states all ULPI pins and
places the part in a low current state
- 1.8V to 3.3V IO Voltage
⢠Single Power Supply Operation
- Integrated 1.8V regulator
- Integrated 3.3V regulator
- 100mV dropout voltage
⢠PHYBoost
- Programmable USB transceiver drive
strength for recovering signal integrity
⢠VariSenseTM
- Programmable USB receiver sensitivity
⢠âWrapper-lessâ design for optimal timing perfor-
mance and design ease
- Low Latency Hi-Speed Receiver (43 Hi-
Speed clocks Max) allows use of legacy
UTMI Links with a ULPI bridge
⢠External Reference Clock operation available
- 19.2MHz Reference Clock needed
- ULPI Clock Input Mode (60MHz sourced by
Link)
- 0 to 3.6V input drive tolerant
- Able to accept ânoisyâ clock sources as refer-
ence to internal, low-jitter PLL
- Crystal support available
⢠Smart detection circuits allow identification of
USB charger, headset, or data cable insertion
⢠Includes full support for the optional On-The-Go
(OTG) protocol detailed in the On-The-Go Sup-
plement Revision 2.0 specification
⢠Supports the OTG Host Negotiation Protocol
(HNP) and Session Request Protocol (SRP)
⢠UART mode for non-USB serial data transfers
⢠Internal 5V cable short-circuit protection of ID, DP
and DM lines to VBUS or ground
⢠Industrial Operating Temperature -40°C to +85°C
⢠32 pin, QFN RoHS Compliant package
(5 x 5x 0.90 mm height)
Applications
The USB3370 is the solution of choice for any applica-
tion where a Hi-Speed USB connection is desired and
when board space, power, and interface pins must be
minimized.
⢠Cell Phones
⢠PDAs
⢠MP3 Players
⢠GPS Personal Navigation
⢠Scanners
⢠External Hard Drives
⢠Digital Still and Video Cameras
⢠Portable Media Players
⢠Entertainment Devices
⢠Printers
⢠Set Top Boxes
⢠Video Record/Playback Systems
⢠IP and Video Phones
⢠Gaming Consoles
ï£ 2012 - 2015 Microchip Technology Inc.
DS00001915B-page 1
|
▷ |