|
USB3300-EZK Datasheet, PDF (1/59 Pages) Microchip Technology – Hi-Speed USB Host, Device or OTG PHY with ULPI Low Pin Interface | |||
|
USB3300
Hi-Speed USB Host, Device or OTG PHY
with ULPI Low Pin Interface
PRODUCT FEATURES
ï® USB-IF Hi-Speed certified to the Universal Serial Bus
Specification Rev 2.0
ï® Interface compliant with the ULPI Specification
revision 1.1 in 8-bit mode
ï® Industry standard UTMI+ Low Pin Interface (ULPI)
Converts 54 UTMI+ signals into a standard 12 pin
Link controller interface
ï® 54.7mA Unconfigured Current (typical) - ideal for bus
powered applications
ï® 83uA suspend current (typical) - ideal for battery
powered applications
ï® Latch-Up performance exceeds 150 mA per
EIA/JESD 78, Class II
ï® ESD protection levels of ±8kV HBM without external
protection devices
ï® Integrated protection to withstand IEC61000-4-2 ESD
tests (±8kV contact and ±15kV air) per 3rd party test
facility
ï® Supports FS pre-amble for FS hubs with a LS device
attached (UTMI+ Level 3)
ï® Supports HS SOF and LS keep-alive pulse
ï® Includes full support for the optional On-The-Go
(OTG) protocol detailed in the On-The-Go
Supplement Revision 1.0a specification
ï® Supports the OTG Host Negotiation Protocol (HNP)
and Session Request Protocol (SRP)
ï® Allows host to turn VBUS off to conserve battery
power in OTG applications
ï® Supports OTG monitoring of VBUS levels with
internal comparators. Includes support for an external
VBUS or fault monitor.
Datasheet
ï® Low Latency Hi-Speed Receiver (43 Hi-Speed clocks
Max) allows use of legacy UTMI Links with a ULPI
wrapper
ï® Integrated Pull-up resistor on STP for interface
protection allows a reliable Link/PHY start-up with
slow Links (software configured for low power)
ï® Internal 1.8 volt regulators allow operation from a
single 3.3 volt supply
ï® Internal short circuit protection of ID, DP and DM
lines to VBUS or ground
ï® Integrated 24MHz Crystal Oscillator supports either
crystal operation or 24MHz external clock input
ï® Internal PLL for 480MHz Hi-Speed USB operation
ï® Industrial Operating Temperature -40°C to +85°C
ï® 32 pin, QFN lead-free RoHS Compliant package
(5 x 5 x 0.90 mm height)
Applications
The USB3300 is the ideal companion to any ASIC, SoC
or FPGA solution designed with a ULPI Hi-Speed USB
host, peripheral or OTG core.
The USB3300 is well suited for:
ï® Cell Phones
ï® PDAs
ï® MP3 Players
ï® Scanners
ï® External Hard Drives
ï® Digital Still and Video Cameras
ï® Portable Media Players
ï® Printers
SMSC USB3300
DATASHEET
Revision 1.1 (01-24-13)
|
▷ |