TC4431_03 Datasheet, PDF (1/17 Pages) Microchip Technology – 1.5A High-Speed 30V MOSFET Drivers

M ^{TC4431/TC4432}
1.5A High-Speed 30V MOSFET Drivers
Features
• High Peak Output Current – 1.5A
• Wide Input Supply Voltage Operating Range:
- 4.5V to 30V
• High Capacitive Load Drive Capability:
- 1000 pF in 25 nsec
• Short Delay Times – <78 nsec Typ.
• Low Supply Current:
- With Logic ‘1’ Input – 2.5 mA
- With Logic ‘0’ Input – 300 µA
• Low Output Impedance – 7Ω
• Latch-Up Protected: Will Withstand >300 mA
Reverse Current
• ESD Protected – 4 kV
Applications
• Small Motor Drive
• Power MOSFET Driver
• Driving Bipolar Transistors
Package Types
8-Pin PDIP/SOIC/CERDIP
V_{DD 1}
8 V_DD
IN 2
LOCK DIS 3
TC4431
7 OUT
6 OUT
GND 4
5 GND
2
7
6
Inverting
V_DD 1
8 V_DD
IN 2
7 OUT
LOCK DIS 3 ^TC4432 6 OUT
GND 4
5 GND
2
7
6
Non Inverting
General Description
The TC4431/TC4432 are 30V CMOS buffer/drivers
suitable for use in high-side driver applications. They
will not latch-up under any conditions within their power
and voltage ratings. They can accept, without damage
or logic upset, up to 300 mA of reverse current (of
either polarity) being forced back into their outputs. All
terminals are fully protected against up to 4 kV of
electrostatic discharge.
Undervoltage lockout circuitry forces the output to a
‘low’ state when the input supply voltage drops below
7V. For operation at lower voltages, disable the lockout
and start-up circuit by grounding pin 3 (LOCK DIS); for
all other situations, pin 3 should be left floating. The
under-voltage lockout and start-up circuit gives brown-
out protection when driving MOSFETS.
 2003 Microchip Technology Inc.
DS21424C-page 1