SST25PF020B Datasheet, PDF (1/33 Pages) Microchip Technology – 2 Mbit 2.3-3.6V SPI Serial Flash

SST25PF020B
2 Mbit 2.3-3.6V SPI Serial Flash
Features
• Single Voltage Read and Write Operations
- 2.3-3.6V
• Serial Interface Architecture
- SPI Compatible: Mode 0 and Mode 3
• High Speed Clock Frequency
- 80 MHz (2.7-3.6V operation)
- 50 MHz (2.3-2.7V operation)
• Superior Reliability
- Endurance: 100,000 Cycles (typical)
- Greater than 100 years Data Retention
• Low Power Consumption:
- Active Read Current: 10 mA (typical)
- Standby Current: 5 µA (typical)
• Flexible Erase Capability
- Uniform 4 KByte sectors
- Uniform 32 KByte overlay blocks
- Uniform 64 KByte overlay blocks
• Fast Erase and Byte-Program:
- Chip-Erase Time: 35 ms (typical)
- Sector-/Block-Erase Time: 18 ms (typical)
- Byte-Program Time: 7 µs (typical)
• Auto Address Increment (AAI) Programming
- Decrease total chip programming time over
Byte-Program operations
• End-of-Write Detection
- Software polling the BUSY bit in Status Register
- Busy Status readout on SO pin in AAI Mode
• Hold Pin (HOLD#)
- Suspends a serial sequence to the memory
without deselecting the device
• Write Protection (WP#)
- Enables/Disables the Lock-Down function of
the status register
• Software Write Protection
- Write protection through Block-Protection bits
in status register
• Temperature Range
- Commercial: 0°C to +70°C
• Packages Available
- 8-lead SOIC (150 mils)
- 8-contact WSON (6mm x 5mm)
- 8-contact USON (3mm x 2mm)
• All non-Pb (lead-free) devices are RoHS compliant
Product Description
The 25 series Serial Flash family features a four-wire,
SPI-compatible interface that allows for a low pin-count
package which occupies less board space and ulti-
mately lowers total system costs. The SST25PF020B
devices are enhanced with improved operating fre-
quency and even lower power consumption.
SST25PF020B SPI serial flash memories are manu-
factured with proprietary, high-performance CMOS
SuperFlash technology. The split-gate cell design and
thick-oxide tunneling injector attain better reliability and
manufacturability compared with alternate approaches.
The SST25PF020B devices significantly improve per-
formance and reliability, while lowering power con-
sumption. The devices write (Program or Erase) with a
single power supply of 2.3-3.6V for SST25PF020B.
The total energy consumed is a function of the applied
voltage, current, and time of application. Since for any
given voltage range, the SuperFlash technology uses
less current to program and has a shorter erase time,
the total energy consumed during any Erase or Pro-
gram operation is less than alternative flash memory
technologies.
The SST25PF020B device is offered in 8-lead SOIC
(150 mils), 8-contact WSON (6mm x 5mm), and 8-con-
tact USON (3mm x 2mm) packages. See Figure 2-1 for
pin assignments.
 2012 Microchip Technology Inc.
DS25135A-page 1