RN1810 Datasheet, PDF (1/36 Pages) Microchip Technology – 2.4 GHz IEEE 802.11b/g/n Wireless Module

RN1810/RN1810E
2.4 GHz IEEE 802.11b/g/n Wireless Module
Features
• IEEE 802.11b/g/n Compliant Transceiver
• 2.4 GHz IEEE 802.11n Single Stream 1x1
• UART Interface to Host Controller (4-wire
including RTS/CTS)
• Integrates Easily into Final Product - Minimizes
Product Development, Provides Quicker Time to
Market
• Configured using Simple ASCII Commands
• Fully Integrated Wireless Module with Voltage
Regulation, Crystal, RF Matching Circuitry, Power
Amplifier (PA), Low Noise Amplifier (LNA), and
PCB Trace Antenna
• Ultra-Small W.FL Connector for External
Antennas (RN1810E)
• Compact Surface Mount Module: 0.700" x 1.050"
x 0.085" (17.8 mm x 26.7 mm x 2.2 mm)
• Castellated Surface Mount Pads for easy and
reliable PCB mounting
• Environmentally Friendly, RoHS Compliant
Operational
• Single Operating Voltage: 3.15V to 3.45V (3.3V
typical)
• Temperature Range: -40°C to +85°C Industrial
• Low-Current Consumption:
- RX mode: 64 mA (typical)
- TX mode: 246 mA at 18 dBm (typical)
• Power Saving Mode:
- Sleep: 12 µA (typical)
RF/Analog
• Frequency: 2.412 to 2.472 GHz
• Channels: 1-13
• Modulation: DSSS, CCK, BPSK, QPSK, 16QAM,
and 64QAM
• Sensitivity: -94 dBm
Antenna
• Integral PCB Trace Antenna (RN1810)
• External Antenna (RN1810E)
Compliance
• Modular Certified for the United States (FCC) and
Canada (IC)
• European R&TTE Directive Assessed Radio
Module
• Australia, New Zealand, Korea, Taiwan, and
Japan
Applications
• Utility and Smart Energy
• Consumer Electronics
• Industrial Controls
• Remote Device Management
• Retail
• Medical, Fitness, and Health Care
Networking
• Supports Infrastructure and SoftAp Networking
Modes
• Built-In Networking Applications: IPv4/IPv6, TCP,
UDP, DHCP, DNS, ICMP, ARP, HTTP, FTP, SNTP,
and SSL/TLS
• Complete On-Board TCP/IP Networking
• Upgrade Firmware Over the Air using TFTP
• Supports Wi-Fi^® Protected Setup (WPS)
 2016 Microchip Technology Inc.
Advance Information
DS50002460A-page 1