MCP7150_16 Datasheet, PDF (1/28 Pages) Microchip Technology – Motion Module

MM7150
Motion Module
Product Features
• High Performance 32-bit Embedded Controller
• Cost effective solution
• Small form factor ideal for embedded applications
• Low power; 13.25mA in active mode
• System in deep sleep consumes 70µA
• Host interface via I²C
• 3.3-Volt I/O
• Package
- 17mm x 17mm, 16-pin module
Sensor Firmware
• Sensor fusion firmware features include:
- Self-contained 9-axis sensor fusion
- Sensor data pass-through
- Fast in-use background calibration of all sen-
sors and calibration monitor
- Magnetic immunity: Enhanced magnetic dis-
tortion, detection and suppression
- Gyroscope drift cancellation
- Fully calibrated
• Easy to implement complete turnkey sensor
fusion solution
• Sensor power management
• Sensors Supported
- Bosch BMC150 Geomagnetic Sensor/Accel-
erometer
- Bosch BMG160 Gyroscope
Hardware Features
The hardware features in the MM7150 module include
the following:
• I²C Controller
- Supports I²C bus speeds to 400kHz
- Host Interface Supports Slave Operation
• Low Power Modes
Target Markets
• Internet of Things Applications
• Remote Controls, Gaming
• Fitness Monitoring
• Applications requiring data from an accelerome-
ter, magnetometer and gyroscope
Temperature Ranges Available
• Industrial (-40°C to +85°C)
• Commercial (0°C to +70°C)
Description
The MM7150 Motion Module is a simple, cost-effective
solution for integrating motion and positioning data into
a wide range of applications. The module contains the
SSC7150 motion coprocessor with integrated 9-axis
sensor fusion as well as high performance MEMS tech-
nology including a 3-axis accelerometer, gyroscope
and magnetometer. All components are integrated, cal-
ibrated and available on the module for PCB mounting.
 2015 - 2016 Microchip Technology Inc.
DS00001888B-page 1