MCP1415_16 Datasheet, PDF (1/17 Pages) Microchip Technology – Tiny 1.5A, High-Speed Power MOSFET Driver

MCP1415/16
Tiny 1.5A, High-Speed Power MOSFET Driver
Features
General Description
• High Peak Output Current: 1.5A (typical)
• Wide Input Supply Voltage Operating Range:
- 4.5V to 18V
• Low Shoot-Through/Cross-Conduction Current in
Output Stage
• High Capacitive Load Drive Capability:
- 470 pF in 13 ns (typical)
- 1000 pF in 18 ns (typical)
• Short Delay Times: 44 ns (t_D1), 47 ns (MCP1415
t_D2), 54 ns (MCP1416 t_D2) (typical)
• Low Supply Current:
- With Logic ‘1’ Input - 0.65 mA (typical)
- With Logic ‘0’ Input - 0.1 mA (typical)
• Latch-Up Protected: Withstands 500 mA Reverse
Current
• Logic Input Withstands Negative Swing up to 5V
• Space-Saving 5L SOT-23 Package
Applications
The MCP1415/16 devices are high-speed, dual
MOSFET drivers that are capable of providing up to
1.5A of peak current while operating from a single 4.5V
to 18V supply. The inverting or non-inverting single
channel output is directly controlled from either TTL or
CMOS (3V to 18V) logic. These devices also feature
low shoot-through current, matched rise and fall time,
and short propagation delays which make them ideal
for high switching frequency applications. They provide
low enough impedances in both the ‘On’ and ‘Off’
states to ensure the intended state of the MOSFET is
not affected, even by large transients.
These devices are highly latch-up resistant under any
condition within their power and voltage ratings. They
are not subject to damage when noise spiking (up to
5V, of either polarity) occurs on the Ground pin. They
can accept up to 500 mA of reverse current being
forced back into their outputs without damage or logic
upset. All terminals are fully protected against
electrostatic discharge (ESD) up to 2.0 kV (HBM) and
300V (MM).
• Switch Mode Power Supplies
• Pulse Transformer Drive
• Line Drivers
• Level Translator
• Motor and Solenoid Drive
Package Types
MCP1415
SOT-23-5
MCP1416
NC 1
5 _OUT
NC ₁
5 OUT
V_DD 2
IN 3
4 GND
V_DD ²
IN 3
4 GND
MCP1415R
NC 1
GND ²
IN 3
5 V_DD
4 OUT
MCP1416R
NC 1
GND ²
IN 3
5 V_DD
4 OUT
 2008-2016 Microchip Technology Inc.
DS20002092G-page 1