MIC39150 Datasheet, PDF (9/12 Pages) Micrel Semiconductor – 1.5A Low-Voltage Low-Dropout Regulator

MIC39150/39151
the PNP-based regulators a distinct advantage over older,
NPN-based linear regulators.
Minimum Load Current
The MIC39150 regulator is specified between finite loads. If
the output current is too small, leakage currents dominate
and the output voltage rises. A 10mA minimum load current
is necessary for proper regulation.
Error Flag
The MIC39151 version features an error flag circuit which
monitors the output voltage and signals an error condition
when the voltage 5% below the nominal output voltage. The
error flag is an open-collector output that can sink 10mA
during a fault condition.
Micrel
Low output voltage can be caused by a number of problems,
including an overcurrent fault (device in current limit) or low
input voltage. The flag is inoperative during overtemperature
shutdown.
Enable Input
The MIC39151 version features an enable input for on/off
control of the device. Its shutdown state draws “zero” current
(only microamperes of leakage). The enable input is TTL/
CMOS compatible for simple logic interface, but can be
connected to up to 20V. When enabled, it draws approxi-
mately 15µA.
May 2000
9
MIC39150/39151