MIC2571_02 Datasheet, PDF (8/12 Pages) Micrel Semiconductor – Single-Cell Switching Regulator

MIC2571
When the output switch turns off, the voltage across the
inductor changes sign and flies high in an attempt to maintain
a constant current. The inductor voltage will eventually be
clamped to a diode drop above V_OUT. Therefore, when the
output switch is off, the voltage across the inductor is:
V₂ = V_OUT + V_DIODE – V_IN
For normal operation the inductor current is a triangular
waveform which returns to zero current (discontinuous mode)
at each cycle. At the threshold between continuous and
discontinuous operation we can use the fact that I₁ = I₂ to get:
V₁ × t₁ = V₂ × t₂
V_{1 =} t₂
V₂
t₁
This relationship is useful for finding the desired oscillator
duty cycle based on input and output voltages. Since input
voltages typically vary widely over the life of the battery, care
must be taken to consider the worst case voltage for each
parameter. For example, the worst case for t₁ is when V_IN is
at its minimum value and the worst case for t₂ is when V_IN is
at its maximum value (assuming that V_OUT, V_DIODE and V_SAT
do not change much).
To select an inductor for a particular application, the worst
case input and output conditions must be determined. Based
on the worst case output current we can estimate efficiency
and therefore the required input current. Remember that this
is power conversion, so the worst case average input current
will occur at maximum output current and minimum input
voltage.
Average I_IN(max) =
V_OUT × I_OUT(max)
V_IN(min) × Efficiency
Micrel
Referring to Figure 1, it can be seen the peak input current will
be twice the average input current. Rearranging the inductor
equation to solve for L:
L=
V
I
× t₁
L=
V_IN(min)
2 × Average I_IN(max)
× t₁
where t₁ =
duty cycle
f_OSC
To illustrate the use of these equations a design example will
be given:
Assume:
MIC2571-1 (fixed oscillator)
V_OUT = 5V
I_OUT(max) =5mA
V_IN(min) = 1.0V
efficiency = 75%.
Average I_IN(max) =
5V × 5mA
1.0V × 0.75
= 33.3mA
L=
1.0V × 0.7
2 × 33.3mA × 20kHz
L = 525µH
Use the next lowest standard value of inductor and verify that
it does not saturate at a current below about 75mA
(< 2 × 33.3mA).
MIC2571
8
1997