MIC4426_05 Datasheet, PDF (7/9 Pages) Micrel Semiconductor – Dual 1.5A-Peak Low-Side MOSFET Driver

MIC4426/4427/4428
Applications Information
Supply Bypassing
Large currents are required to charge and discharge large
capacitive loads quickly. For example, changing a 1000pF
load by 16V in 25ns requires 0.8A from the supply input.
To guarantee low supply impedance over a wide frequency
range, parallel capacitors are recommended for power supply
bypassing. Low-inductance ceramic MLC capacitors with short
lead lengths (< 0.5”) should be used. A 1.0µF film capacitor
in parallel with one or two 0.1µF ceramic MLC capacitors
normally provides adequate bypassing.
Grounding
When using the inverting drivers in the MIC4426 or MIC4428,
individual ground returns for the input and output circuits or
a ground plane are recommended for optimum switching
speed. The voltage drop that occurs between the driver’s
ground and the input signal ground, during normal high-cur-
rent switching, will behave as negative feedback and degrade
switching speed.
Control Input
Unused driver inputs must be connected to logic high (which
can be V_S) or ground. For the lowest quiescent current
(< 500µA) , connect unused inputs to ground. A logic-high
signal will cause the driver to draw up to 9mA.
The drivers are designed with 100mV of control input hys-
teresis. This provides clean transitions and minimizes output
stage current spikes when changing states. The control input
voltage threshold is approximately 1.5V. The control input
recognizes 1.5V up to V_S as a logic high and draws less than
1µA within this range.
The MIC4426/7/8 drives the TL494, SG1526/7, MIC38C42,
TSC170 and similar switch-mode power supply integrated
circuits.
Micrel, Inc.
Power Dissipation
Power dissipation should be calculated to make sure that the
driver is not operated beyond its thermal ratings. Quiescent
power dissipation is negligible. A practical value for total
power dissipation is the sum of the dissipation caused by the
load and the transition power dissipation (P_L + P_T).
Load Dissipation
Power dissipation caused by continuous load current (when
driving a resistive load) through the driver’s output resistance
is:
P_L = I_L2 R_O
For capacitive loads, the dissipation in the driver is:
P_L = f C_L V_S2
Transition Dissipation
In applications switching at a high frequency, transition power
dissipation can be significant. This occurs during switching
transitions when the P-channel and N-channel output FETs
are both conducting for the brief moment when one is turning
on and the other is turning off.
P_T = 2 f V_S Q
Charge (Q) is read from the following graph:
1×10^-8
8×10^-9
6×10^-9
4×10^-9
3×10^-9
2×10^-9
1×10^-9
4
6 8 10 12 14 16 18
SUPPLY VOLTAGE (V)
Crossover Energy Loss per Transition
April 2008
7
M9999-042108