English
Language : 

MIC3003_11 Datasheet, PDF (66/75 Pages) Micrel Semiconductor – FOM Management IC with Internal Calibration
Micrel, Inc.
MIC3003
OEM Configuration 3 (OEMCFG3)
D[7]
QGPOM
read/write
D[6]
TXFPOL
read/write
D[5]
GPOD
read/write
D[4]
GPOM
read/write
D[3]
GPOC
read/write
D[2]
TXFINM
read/write
D[1]
LOSDIS
read/write
D[0]
INTCAL
read/write
Default value
0000 1000b = 08h
Serial address
A6h
Byte address
19 = 13h
This register is non-volatile and will be maintained through power and reset cycles. A valid OEM password is required for access
to this register.
Bit
Function
D[7]
QGPOM QGPO pin function select
D[6]
TXFPOL TXFIN active polarity select; a fault is
indicated when TXFIN = TXFPOL
D[5]
GPOD GPO output drive
D[4]
GPOM GPO/RRSOUT pin mode select
D[3]
GPOC GPO output control
D[2]
TXFINM SHDN/TXFIN pin mode select
D[1]
LOSDIS RXLOS comparator and output disable
D[0]
INTCAL Calibration mode select
Operation
0: GPO (general purpose output)
1: Reset output
0 = The TXFIN input is active-low
1 = The TXFIN input is active-high
This bit is ignored if TXFINM = 0
0 = GPO output is open-drain
1 = GPO output is push-pull
This bit is ignored if GPOM = 0
0 = RRSOUT output
1 = GPO output
0 = Set the GPO pin low
1 = Set the GPO pin high
This bit is ignored if GPOM = 0
0 = SHDN output
1 = TXFIN input
0 = RXLOS fault enabled, and the RXLOS output is enabled
for normal operation
1 = RXLOS fault disabled; also, the RXLOS output is
disabled, and will remain low
0 = External calibration mode
1 = Internal calibration.(the MIC3003’s ALU applies slope
and offset coefficients to the ALU results as necessary)
BIAS DAC Setting (APCDAC)
Current VBIAS Setting
D[7]
read-only
D[6]
read-only
D[5]
read-only
D[4]
read-only
D[3]
read-only
D[2]
read-only
D[1]
read-only
D[0]
read-only
Default value
Serial address
Byte address
0000 0000b = 00h
A6h
20 = 14h
This register reflects (reads back) the value being sent to the BIAS DAC (APCSET0, APCSET1, or APCSET2 whichever is
selected, with temperature compensation applied).
A valid OEM password is required for access to this register.
November 2009
66
M9999-111209-C
hbwhelp@micrel.com or (408) 955-1690