MIC7211 Datasheet, PDF (4/8 Pages) Micrel Semiconductor – IttyBitty™ Rail-to-Rail Input Comparator Preliminary Information

MIC7211/7221
Micrel
AC Electrical Characteristics
V_V– = 0V, V_CM = V_OUT = V_V+/2; T_J = 25°C, bold values indicate –40°C ≤ T_J ≤ +85°C; Note 7; unless noted
Symbol
Parameter
Condition
Min
t_RISE
Rise Time
V_V+ = 5.0V, f = 10kHz, C_LOAD = 50pF
overdrive = 10mV, Note 9
t_FALL
Fall Time
V_V+ = 5.0V, f = 10kHz, C_LOAD = 50pF
overdrive = 10mV, Note 9
t_PHL
Propagation Delay-High to Low
V_V+ = 2.2V, f = 10kHz, C_LOAD = 50pF
overdrive = 10mV, Note 9
V_V+ = 2.2V, f = 10kHz, C_LOAD = 50pF
overdrive = 100mV, Note 9
V_V+ = 5.0V, f = 10kHz, C_LOAD = 50pF
overdrive = 10mV, Note 9
V_V+ = 5.0V, f = 10kHz, C_LOAD = 50pF
overdrive = 100mV, Note 9
t_PLH
Propagation Delay-Low to High
V_V+ = 2.2V, f = 10kHz, C_LOAD = 50pF
overdrive = 10mV, Note 9
V_V+ = 2.2V, f = 10kHz, C_LOAD = 50pF
overdrive = 100mV, Note 9
V_V+ = 5.0V, f = 10kHz, C_LOAD = 50pF
overdrive = 10mV, Note 9
V_V+ = 5.0V, f = 10kHz, C_LOAD = 50pF
overdrive = 100mV, Note 9
Typ
75
70
10
6.0
13
5
13.5
4.0
11.5
3.0
Max Units
ns
ns
µs
µs
µs
µs
µs
µs
µs
µs
Note 1.
Note 2.
Note 3.
Note 4.
Note 5.
Note 6.
Note 7.
Note 8.
Note 9.
Exceeding the absolute maximum rating may damage the device.
The device is not guaranteed to function outside its operating rating.
I/O pin voltage is any external voltage to which an input or output is referenced.
The maximum allowable power dissipation is a function of the maximum junction temperature, T_J(max); the junction-to-ambient thermal
resistance, θ_JA; and the ambient temperature, T_A. The maximum allowable power dissipation at any ambient temperature is calculated using
P_D(max) = (T_J(max) – T_A) ÷ θ_JA. Exceeding the maximum allowable power dissipation will result in excessive die temperature.
Thermal resistance, θ_JA, applies to a part soldered on a printed circuit board.
Devices are ESD sensitive. Handling precautions recommended.
All limits guaranteed by testing on statistical analysis.
Continuous short circuit may exceed absolute maximum T_J under some conditions.
The MIC7221 requires 5kΩ pull-up resistor.
Partial Functional Diagrams
V+
V+
OUT
OUT
V–
MIC7211 Push-Pull Output
V–
MIC7221 Open-Drain Output
MIC7211/7221
4
June 1999