MIC29710 Datasheet, PDF (4/8 Pages) Micrel Semiconductor – 7.5A Fast-Response LDO Regulator

MIC29710/29712
Micrel
Parameter
Conditions
Min Typical Max Units
Enable Input (MIC29712 only)
Input Logic Voltage
Enable (EN) Pin Input Current
Low (Off)
High (On)
V_EN = V_IN
V_EN = 0.8V
Regulator Output
Current in Shutdown
(Note 8)
0.8
V
2.4
V
15
30
µA
75
µA
–
2
µA
4
µA
10
µA
20
µA
General Note: Devices are ESD sensitive. Handling precautions are recommended.
Note 1: The maximum continuous supply voltage is 16V.
Note 2:
Note 3:
Note 4:
Note 5:
For testing, MIC29712 V_OUT is programmed to 5V.
Dropout voltage is defined as the input-to-output differential when the output voltage drops to 99% of its nominal value with V_OUT + 1V applied
to V_IN.
For this test, V_IN is the larger of 8V or V_OUT + 3V.
Ground pin current is the regulator quiescent current. The total current drawn from the source is the sum of the load current plus the ground
pin current.
Note 6: Output voltage temperature coefficient is defined as the worst case voltage change divided by the total temperature range.
Note 7: V_REF ≤ V_OUT ≤ (V_IN – 1 V), 2.4V ≤ V_IN ≤ 8V, 10mA < I_L ≤ 7.5A, T_J ≤ T_{J MAX.}
3
Note 8: V_EN ≤ 0.8V and V_IN ≤ 16V, V_OUT = 0.
Block Diagram
IN
Bias
EN
On/Off
Reference
Thermal
Shut-
down
O.V.
I_LIMIT
2186VV
OUT
Feed-
back
ADJ
GND
1997
3-107