MIC26603 Datasheet, PDF (3/30 Pages) Micrel Semiconductor – 28V, 6A Hyper Light Load Synchronous DC/DC Buck Regulator

Micrel, Inc.
MIC26603
Pin Description (Continued)
Pin Number
22
23
24
25
26
27
28
Pin Name
CS
SGND
FB
PG
EN
VIN
VDD
Pin Function
Current Sense (input): The CS pin senses current by monitoring the voltage across the low-side
MOSFET during the OFF-time. The current sensing is necessary for short circuit protection and zero
current cross comparator. In order to sense the current accurately, connect the low-side MOSFET
drain to SW using a Kelvin connection. The CS pin is also the high-side MOSFET’s output driver
return.
Signal ground. SGND must be connected directly to the ground planes. Do not route the SGND pin
to the PGND Pad on the top layer, see PCB layout guidelines for details.
Feedback (Input): Input to the transconductance amplifier of the control loop. The FB pin is
regulated to 0.8V. A resistor divider connecting the feedback to the output is used to adjust the
desired output voltage.
Power Good (Output): Open Drain Output. The PG pin is externally tied with a resistor to VDD. A
high output is asserted when V_OUT > 92% of nominal.
Enable (input): A logic level control of the output. The EN pin is CMOS-compatible. Logic high =
enable, logic low = shutdown. In the off state, supply current of the device is greatly reduced
(typically 5µA). The EN pin should not be left open.
Power Supply Voltage (Input): Requires bypass capacitor to SGND.
5V Internal Linear Regulator (Output): VDD supply is the supply bus for the IC control circuit. V_DD is
created by internal LDO from V_IN. When V_IN < +5.5V, VDD should be tied to PVIN pins. A 1.0µF
ceramic capacitor from the VDD pin to SGND pins must be place next to the IC.
July 2011
3
M9999-071311-A