MIC2593_08 Datasheet, PDF (3/26 Pages) Micrel Semiconductor – Dual-Slot PCI Hot Plug Controller

Micrel, Inc.
Pin Configuration
Hot-Plug
Control
Interface
MIC2593
/FAULTA
CFILTERA
12VSLEW
GPI
12VINA
5VINA
5VSENSEA
5VGATEA
5VOUTA
12VOUTA
VSTBYA
3VINA
/FAULTB
CFILTERB
12VSLEWB
GND
12VINB
5VINB
5VSENSEB
5VGATEB
5VOUTB
12VOUTB
VSTBYB
3VINB
Slot A
Interface
48-Pin TQFP (TQ)
Slot B
Interface
Pin Description
Pin Number
5, 32
10, 27
17, 18
19, 20
3, 34
Pin Name
12VINA, 12VINB
12VOUTA, 12VOUTB
12MVINA, 12MVINB
12MVOUTA, 12MVOUTB
12VSLEWA, 12VSLEWB
Pin Function
+12V Supply Power [A/B]: Pin 5 is the input to the drain side of the internal
MOSFET switch for +12V Slot A. Pin 32 is the input to the drain side of the
internal MOSFET switch for +12V Slot B. These two pins must ultimately
connect to each other within 10cm of the MIC2593. An undervoltage lockout
circuit (UVLO) prevents the switches from turning on while this input is less than
its lockout threshold.
+12V Output [A/B]: Pin 10 is connected to the source terminal of the internal
MOSFET switch for +12V Slot A and pin 27 is connected similarly for Slot B.
–12V Supply Power [A/B]: Pin 17 is the input to the drain side of the internal
MOSFET switch for +12V Slot A. Pin 18 is the input to the drain side of the
internal MOSFET switch for –12V Slot B. These two pins must ultimately
connect to each other within 10cm of the MIC2593. An undervoltage lockout
circuit (UVLO) prevents the switches from turning on while this input is less than
its lockout threshold.
–12V Output [A/B]: Pin 19 is connected to the source terminal of the internal
MOSFET switch for –12V Slot A and pin 20 is connected similarly for Slot B.
12V Slew Rate Control [A/B]: Connect capacitors between these pins and
ground to set the output slew rates of the +12V and –12V supplies. See the
“Functional Description” section for more details.
September 2008
3
M9999-092208