SY100EL14V_06 Datasheet, PDF (1/5 Pages) Micrel Semiconductor – 5V/3.3V 1:5 CLOCK DISTRIBUTION

Micrel, Inc.
5V/3.3V 1:5 CLOCK
DISTRIBUTION
Precision Edge^®
Precision^SYE¹d⁰⁰g^Ee^L®14V
SY100EL14V
FEATURES
s 3.3V and 5V power supply options
s Typical 30ps output-to-output skew
s Max. 50ps output-to-output skew
s Synchronous enable/disable
s Multiplexed clock input
s 75KΩ internal input pull-down resistors
s Available in 20-pin SOIC package
Precision Edge^®
DESCRIPTION
The SY100EL14V is a low skew 1:5 clock distribution
chip designed explicitly for low skew clock distribution
applications. The device can be driven by either a
differential or single-ended ECL or, if positive power
supplies are used, PECL input signal. The EL14V is
suitable for operation in systems operating from 3.3V to
5.0V supplies. If a single-ended input is to be used the
VBB output should be connected to the CLK input and
bypassed to ground via a 0.01µF capacitor. The VBB
output is designed to act as the switching reference for
the input of the EL14V under single-ended input
conditions, as a result this pin can only source/sink up to
0.5mA of current.
The EL14V features a multiplexed clock input to allow
for the distribution of a lower speed scan or test clock
along with the high speed system clock. When LOW (or
left open and pulled LOW by the input pull-down resistor)
the SEL pin will select the differential clock input.
The common enable (EN) is synchronous so that the
outputs will only be enabled/disabled when they are
already in the LOW state. This avoids any chance of
generating a runt clock pulse when the device is enabled/
disabled as can happen with an asynchronous control.
The internal flip flop is clocked on the falling edge of the
input clock, therefore all associated specification limits
are referenced to the negative edge of the clock input.
When both differential inputs are left open, CLK input
will pull down to VEE and CLK input will bias around
VCC/2.
Precision Edge is a registered trademark of Micrel, Inc.
M9999-031006
[e-mail] or [phone]
1
Rev.: D
Amendment: /0
Issue Date: March 2006