|
MIC5210 Datasheet, PDF (1/8 Pages) Micrel Semiconductor – Dual 150mA LDO Regulator Preliminary Information | |||
|
MIC5210
MIC5210
Dual 150mA LDO Regulator
Preliminary Information
General Description
The MIC5210 is a dual linear voltage regulator with very low
dropout voltage (typically 10mV at light loads and 140mV at
100mA), very low ground current (225µA at 10mA output), and
better than 1% initial accuracy. It also features individual logic-
compatible enable/shutdown control inputs.
Both regulator outputs can supply up to 150mA at the same
time as long as each regulatorâs maximum junction tempera-
ture is not exceeded.
Designed especially for hand-held battery powered devices,
the MIC5210 can be switched by a CMOS or TTL compatible
logic signal, or the enable pin can be connected to the supply
input for 3-terminal operation. When disabled, power con-
sumption drops nearly to zero. Dropout ground current is
minimized to prolong battery life.
Key features include current limiting, overtemperature shut-
down, and protection against reversed battery.
The MIC5210 is available in 2.7V, 2.8V, 3.0V, 3.3V, 3.6V, 4.0V
and 5.0V fixed voltage configurations. Other voltages are
available; contact Micrel for details.
Features
⢠Micrel Mini 8⢠MSOP package
⢠Up to 150mA per regulator output
⢠Low quiescent current
⢠Low dropout voltage
⢠Wide selection of output voltages
⢠Tight load and line regulation
⢠Low temperature coefficient
⢠Current and thermal limiting
⢠Reversed input polarity protection
⢠Zero off-mode current
⢠Logic-controlled electronic enable
Applications
⢠Cellular telephones
⢠Laptop, notebook, and palmtop computers
⢠Battery powered equipment
⢠Bar code scanners
⢠SMPS post regulator/dc-to-dc modules
⢠High-efficiency linear power supplies
Micrel
Ordering Information
Part Number
Voltage Accuracy Junction Temp. Range*
MIC5210-2.7BMM 2.7
1.0%
â40°C to +125°C
MIC5210-2.8BMM 2.8
1.0%
â40°C to +125°C
MIC5210-3.0BMM 3.0
1.0%
â40°C to +125°C
MIC5210-3.3BMM 3.3
1.0%
â40°C to +125°C
MIC5210-3.6BMM 3.6
1.0%
â40°C to +125°C
MIC5210-4.0BMM 4.0
1.0%
â40°C to +125°C
MIC5210-5.0BMM 5.0
1.0%
â40°C to +125°C
Other voltages available. Contact Micrel for details.
Package
8-lead MSOP
8-lead MSOP
8-lead MSOP
8-lead MSOP
8-lead MSOP
8-lead MSOP
8-lead MSOP
Typical Application
Output A
1µF
tantalum
Output B
2.2µF
tantalum
MIC5210
1
8
2
7 Enable A
3
6
4
CBYP
470pF
5 Enable B
1µF
Enable may be connected to VIN
Low-Noise + Ultralow-Noise (Dual) Regulator
MM8 and Micrel Mini 8 are trademarks of Micrel, Inc.
Micrel, Inc. ⢠1849 Fortune Drive ⢠San Jose, CA 95131 ⢠USA ⢠tel + 1 (408) 944-0800 ⢠fax + 1 (408) 944-0970 ⢠http://www.micrel.com
February 2000
1
MIC5210
|
▷ |