MIC2179_09 Datasheet, PDF (1/13 Pages) Micrel Semiconductor – 1.5A Synchronous Buck Regulator

Micrel, Inc.
MIC2179
MIC2179
1.5A Synchronous Buck Regulator
General Description
The Micrel MIC2179 is a 200kHz synchronous buck (step-
down) switching regulator designed for high-efficiency, bat-
tery-powered applications.
The MIC2179 operates from a 4.5V to 16.5V input and features
internal power MOSFETs that can supply up to 1.5A output
current. It can operate with a maximum duty cycle of 100%
for use in low-dropout conditions. It also features a shutdown
mode that reduces quiescent current to less than 5µA.
The MIC2179 achieves high efficiency over a wide output
current range by operating in either PWM or skip mode. The
operating mode is externally selected, typically by an intel-
ligent system, which chooses the appropriate mode according
to operating conditions, efficiency, and noise requirements.
The switching frequency is preset to 200kHz and can be
synchronized to an external clock signal of up to 300kHz.
The MIC2179 uses current-mode control with internal current
sensing. Current-mode control provides superior line regula-
tion and makes the regulator control loop easy to compensate.
The output is protected with pulse-by-pulse current limiting
and thermal shutdown. Undervoltage lockout turns the output
off when the input voltage is less than 4.5V.
The MIC2179 and is packaged in a 20-lead SSOP package
with an operating temperature range of –40°C to +85°C.
Features
• 4.5V to 16.5V input voltage range
• Dual-mode operation for high efficiency (up to 96%)
PWM mode for > 150mA load current
Skip mode for <150mA load current
• 150mΩ internal power MOSFETs at 12V input
• 200kHz preset switching frequency
• Low quiescent current
1.0mA in PWM mode
600µA in skip mode
< 5µA in shutdown mode
• Current-mode control
Simplified loop compensation
Superior line regulation
• 100% duty cycle for low dropout operation
• Current limit
• Thermal shutdown
• Undervoltage lockout
Applications
• High-efficiency, battery-powered supplies
• Buck (step-down) dc-to-dc converters
• Cellular telephones
• Laptop computers
• Hand-held instruments
• Battery Charger
Typical Application
V_IN
5.4V to 16.5V
C1
10µF
20V
R1
20k
Output Good
Output Low
Skip Mode
PWM Mode
U1
16,17
15
EN
VIN
3,4
SW
6
5
PWRGD _MIC
PWM ^2179-3.3
PGND
1,2,
19,20
13 _SYNC
FB ⁷
COMP SGND BIAS
8
9–12
14
L1
22µH
D1
MBRM120
V_OUT
3.3V/600mA
C2
100µF
6.3V
C4
6.8nF
C3
0.01µF
R5
4.02k
Pins 4 and 18 are not connected.
Pins 3 and 4 can be connected
together for a low-impedance
connection.
Micrel, Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel + 1 [phone] • fax + 1 [phone] • http://www.micrel.com
June 2009
1
M9999-063009