|
SA10A Datasheet, PDF (1/4 Pages) MERITEK ELECTRONICS CORPORATION – Transient Voltage Suppressors | |||
|
Transient 9ROWDJH6XSSUHVVRUV
SA Series
FEATURES
 Plastic Sackage.
 Glass passivated chip junction.
 500W Peak Pulse Power capability on 10/1000µs waveform.
 Excellent clamping capability.
 Repetition rate (duty cycle): 0.01%.
 Low incremental surge resistance.
 Fast response time: typically less than 1.0ps from 0 volt to BV for
8nidirectional and 5.0ns for %idirectional types.
 Tiypical IR less than 1µA above 10V.
 High temperature soldering guaranteed: 265°C/10 seconds/.375",
((9.5mm) lead length, 5lbs, (2.3kg) tension.
MERITEK
6
UL E223045
DO-204AC/DO-15
6
MMECHANICAL DATA
 Case: JEDEC DO-15 Molded plastic over glass passivated junction.
MÂ Terminals: Plated Axial leads, solderable per MIL-STD-750, Method 2026.
 Polarity: Color band denotes cathode except Bidirectional.
 Mounting Position: Any.
 Weight: 0.015 ounce, 0.4 grams.
DEVICES FOR BIPOLAR APPLICATION
For %idirectional use C or CA suffix for type SA5.0 through type SA220 (e.g. SA5.0C, SA220CA);
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Ratings at 25Ä ambient temperature unless otherwise specified.
RATING
SYMBOL
VALUE
UNIT
Peak Pulse Power Dissipation on 10/1000Ès waveform. (Note1ËFig.1)
PPPM
Peak Pulse Current on 10/1000Ès waveform. (Note1Fig.3)
,PPM
Steady State Power Dissipation at TL =75ÄËLead length .375â (9.5mm).
( Fig.5)
PM(AV)
Peak Forward Surge CurrentË8.3ms Single Half Sine-Wave Superimposed
on Rated Load. (JEDEC Method) (Note 2, Fig.6)
IFSM
Operating junction and Storage Temperature Range.
TJ , TSTG
Minimum 500 Watts
See Table
Amps
3.0
Watts
70
-55 to +175
Amps
Ä
Notes: 1. Non-repetitive current pulse, per Fig.3 and derated above TA = 25Ä per Fig.2.
2. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minute maximum.
All specifications are subject to change without notice.
1
Rev 7
|
▷ |