P6SMB Datasheet, PDF (1/4 Pages) Taiwan Semiconductor Company, Ltd – Surface Mount Transient Voltage Suppressor

Transient Voltage Suppressors
P6SMB Series
MERITEK
FEATURES
For surface mounted applications in order to optimize board space.
Low profile package.
Built-in strain relief.
Glass passivated junction.
Low inductance.
Excellent clamping capability.
Repetition Rate (duty cycle): 0.01%.
Fast response time: typically less than 1.0ps from 0 volt to VBR for Unidirectional types.
Typical IR less than 1μA above 10V.
High Temperature soldering: 260°C/10 seconds at terminals.
P
MECHANICAL DATA
M _{Case: JEDEC DO--221041AMA.oMldoelddePdlapsltaics.tic over glass passivated junction.}
Terminals: :SAoxldiaelrlepaladtse,ds, oslodledrearbalbelepeprerMMILI-LS-STDTD-7-5705,0M, Metehtohdod2022062.6.
Polarity: Color abnadnddedneontoetsesctchaothdoedeexceexpceBptipBoidlair.ectional.
MStoaunndtainrdg Paocskitaiognin: gA:n1y.2mm tape (EIA STD RS-481).
Weight: 0.003 ounce, 0.093 grams.
DEVICES FOR BIPOLAR APPLICATION
For Bidirectional use CA suffix for type P6SMB6.8CA through type P6SMB550CA;
Electrical characteristics apply in both directions.
UL E223045
SMB/DO-214AA
MAXIMUM RATINGS AND CHARACTERISTICS
Ratings at 25ć ambient temperature unless otherwise specified.
RATING
SYMBOL
VALUE
Peak Pulse Power Dissipation on 10/1000ȝs waveform. (Note 1, Note 2, Fig. 1)
Peak Pulse Current on 10/1000ȝs waveform. (Note 1,Fig. 3)
Steady State Power Dissipation at T_L =75ćˈLead length .375”ˈ(9.5mm).
(Note 2, Fig. 5)
Peak Forward Surge Currentˈ8.3ms Single Half Sine-Wave Superimposed
on Rated Load. (JEDEC Method) (Note 3, Fig. 6)
Operating junction and Storage Temperature Range.
P_PPM
I_PPM
P_M(AV)
I_FSM
T_J , T_STG
Minimum 600
See Table
5.0
100
-65 to +150
Notes: 1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25ć per Fig. 2.
N _{2. Mounted on 5.0mm x 5.0mm (0.03mm thick) Copper Pads to each terminal.}
3. 8.3²ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minute maximum.
.
UNIT
Watts
Amps
Watts
Amps
ć
All specifications are subject to change without notice.
1
Rev 7