|
5KP Datasheet, PDF (1/4 Pages) Surge Components – GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR VOLTAGE-5.0 to 110 Volts | |||
|
Transient 9ROWDJH6XSSUHVVRUV
5KP Series
FEATURES
 Plastic package.
 Glass passivated chip junction.
 5,000W Peak Pulse Power capability on 10/1000µs waveform.
 Excellent clamping capability.
 Repetition rate (duty cycle): 0.05%.
 Low incremental surge resistance.
 Fast response time: typically less than 1.0ps from 0 volt to BV min.
 Typical IR less than 2µA for VBR>=10V.
 Hi igh temperature soldering guaranteed: 265°C/10 seconds/.375",
(9.5mm) lead length, 5lbs, (2.3kg) tension.
(
MERITEK
6
UL E223045
P600
MMECHANICAL DATA
 Case: Molded plastic over glass passivated junction.
MÂ Terminals: Plated Axial leads, solderable per MIL-STD-750, Method 2026.
 Polarity: Color band denotes cathode except Bipolar.
 Mounting Position: Any.
 Weight: 0.07 ounce, 2.15 grams.
DEVICES FOR BIPOLAR APPLICATION
For Bidirectional use C or CA suffix for type 5KP5.0 through type 5KP250 (e.g. 5KP5.0C, 5KP250CA);
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Ratings at 25Ä ambient temperature unless otherwise specified.
RATING
SYMBOL
VALUE
Peak Pulse Power Dissipation on 10/1000Ès waveform. (Note 1ËFig. 1)
Peak Pulse Current on 10/1000Ès waveform. (Note 1ËFig. 3)
Steady State Power Dissipation at TL =75ÄËLead length .375â (9.5mm).
( Fig. 5)
Peak Forward Surge CurrentË8.3ms Single Half Sine-Wave Superimposed
on Rated Load. (JEDEC Method) (Note 2, Fig. 6)
PPPM
IPPM
PM(AV)
IFSM
Minimum 5,000
See Table
8.0
400
Operating junction and Storage Temperature Range.
TJ , TSTG
-55 to +175
Notes: 1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25Ä per Fig. 2.
2. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minute maximum.
UNIT
Watts
Amps
Watts
Amps
Ä
All specifications are subject to change without notice.
1
Rev 7
|
▷ |