MLX92292 Datasheet, PDF (5/11 Pages) Melexis Microelectronic Systems – μ-Power Programmable ASIL B capable Hall Effect Switch/Latch

MLX92292
µ-Power Programmable ASIL B capable
Hall Effect Switch/Latch
3 Magnetic Specifications – Normal (vertical) Sensitive Version
DC Operating Parameters V_DD = 3.3V to 18V, T_A = -40°C to 150°C (unless otherwise specified)
Parameter
Symbol Test Conditions
Min
Typ⁽²⁾
Max
Operating Point programming range⁽²⁾
BOP
VDD =12V, TA =25°C
-90
─
90
Release Point programming range⁽²⁾
BRP
VDD =12V, TA =25°C
-90
─
90
Operating Point magnitude programming^{(3, 4)} BOP
─
12
─
Release Point magnitude programming^{(3, 4)} BRP
─
12
─
Operating Point polarity selection
BOP
─
1
─
Release Point polarity selection
BRP
─
1
─
Direct or inverted output selection
─
1
─
Factory pre-programmed Operating Point,
Latch
BOP
VDD =12V, TA =25°C,
programming target 28mT
26
28
30
Factory pre-programmed Release Point,
Latch
BRP
VDD =12V, TA =25°C,
programming target -28mT
-26
-28
-30
Temperature Coefficient programming
range^{(5, 6)}
TC
VDD =12V, Latch with
BOP =28mT, BRP = -28mT
-2400
0
Temperature Coefficient selection
─
5
─
Units
mT
mT
bit
bit
bit
bit
bit
mT
mT
ppm/ºC
bit
Notes:
1. Unless otherwise specified the typical values are defined at TA = +25ºC and VDD = 12V
2. Guaranteed by correlation with production test at B=28mT and verified by characterization
3. The programming step is <0.5% of the programmed BOP value for |BOP| ≥ 6mT and <0.02mT for |BOP| ≤ 6mT at TA = +25ºC
4. Programming of very low hysteresis magnitude (BOP – BRP < 1mT) could lead to output toggling due to noise and mechanical looseness
in the magnetic system.
5. TC target values
6. The Temperature Coefficient is calculated using the following formula:
TC

(B_OPTA2  B_RPTA2 )  (B_OPTA1
(B_OPTA1  B_RPTA1) * (T_A2
 B_RPTA1
 T_A1)
)
*10⁶
,
p
p
m/^o
C;
T_A1

25^o C; T_A2
 150^o C
The factory pre-programmed target TC value is 0ppm/ºC.
µ-Power Programmable ASIL B Hall S/L
Rev. 1.1
Page 5 of 11
Abstract
Sept 11, 2015