PTC04-DB-HALL03 Datasheet, PDF (3/8 Pages) Melexis Microelectronic Systems – Daughter Board for Melexis PTC devices

2. Board description
2.1. Board Layout
PTC04-DB-HALL03
Daughter Board for Melexis PTC devices
J3: Jumpers to connect the measurement sense lines immediately to the force lines. These
jumpers are needed when no force and sense is used.
DB-ID: This ID keeps a few initial variables in mind. It allows for example to detect what DB is
connected to the programmer and if the DB is not expired.
J5, J6: Analogue and Digital connector: See below for a detailed description.
DB Connector: Connector to the application. See below for details.
LED Indicators: 8 LED Indicators for the DB_IOdrv lines.
J1: 10 pins Screw Terminal. It provides the same signals as the application connector.
PTC04-DB-HALL03
Rev. 1.4
Page 3 of 8
Datasheet
May 2011