MLX90215_12 Datasheet, PDF (10/14 Pages) Melexis Microelectronic Systems – Position Programmable Linear Hall Effect Sensor

MLX90215
Position Programmable
Linear Hall Effect Sensor
8 Clamping the Output Voltage
The MLX90215 has a 2-bit CLAMP feature which allows
Four output voltage options. The CLAMP
feature is independent of the gain,
and will not effect sensitivity of the device. The table below illustrates
limits for each of the four options.
Bit Value
Limits (% VDD)
0
(default) no clamp
1
5 to 45
2
10 to 90
3
5 to 95
Bit Allocation Table
9 Application comments
The following is a list of recommended operating
parameters that will help to ensure the accuracy and
stability of the MLX90215. These are not the absolute
programming limits of the device.
1.) Voq is best programmed in the absence of any
magnetic influence and to voltages closest to 1/2
VDD, where temperature drift will be +/-0.4% or
less. It is not recommended to use VOQ values close
to 0 volts or VDD when programming extremely
high sensitivity (> 100 mV/mT) values. Temperature
instability may be observed on some devices
under these conditions.
2.) Best linearity of sensitivity is obtained when VOQ i s
programmed at 1/2VDD. This is with the 1/2VDD
function enabled.
3.) Best linearity of sensitivity is obtained when the
gain is programmed between 5mV/mT and
100mV/mT.
4.) Best temperature stability is realized when the
temperature compensation function is programmed
to zero ppm/oC.
5.) The Test/Readback pin is for diagnostic use only.
This pin is normally tied to GND. Contact Melexis
for more details on programming this device.
10 Installation Comments
1.) Avoid mechanical stress on leads or package.
Stress may cause VOQ shift.
A.) Avoid bending leads at the package interface.
B.) Support the leads by clamping, when bending.
C.) Avoid gluing device to another material. This
may cause temperature-related stress.
2.) CMOS products are static sensitive devices, please
observe ESD precautions.
3.) Observe temperature limits during soldering
3901090215
Rev 008
Page 10 of 14
Nov/12