MLX90109 Datasheet, PDF (1/15 Pages) List of Unclassifed Manufacturers – 125kHz RFID Integrated Transceiver

MLX90109
125kHz RFID Transceiver
Features and Benefits
Integrated RFID transceiver
Adressing 100kHz to 150kHz frequency range transponder.
Biphase and Manchester ASK.
ON/OFF keying modulation.
Low Power and high performances
Unique Parallel Antenna concept for maximum power efficiency.
Power down mode available.
Baud rate selectable “on-chip” filtering for maximum sensitivity.
No zero modulation problems.
Low cost and compact design
SO8 package and high level of integration for compact reader design.
No external quartz reference required, only 2 resistors plus antenna.
On chip decoding for fast system design and ease of use.
Open drain data and clock outputs for 2-wire serial communication.
Applications Examples
Car Immobilizers
Portable readers
Access control
House held appliances
Ordering Information
Part No.
MLX90109
MLX90109
Temperature Code
C (0°C to 70°C)
E (-40°C to 85°C)
Package Code
DC (SOIC 8)
DC (SOIC 8)
Option code
--
--
1 Functional diagram
VDD
¡£¢¤¢
¥£¦¤§ ¨
¤!"¤
©¦¤¢ _{#%$'&)(021¤3 46587 (29}
9"@65BAC(EDGF
RST UW V
&H7 IPD (6IQ(29"5%D (23 3 @ED
X8YB`8a ©b¦P¢6c"d e£fQcQc8¢hgGiQpQq r sutwvQx x r pQsyt
XB€8`8a ¢¤y‚Q£dB¥y¨¦¤¥bƒ„iy…Qx †y…Qx t
2 Description
The MLX90109 is a single chip RFID transceiver
for the 125kHz frequency range. It has been
conceived for minimum system cost and minimum
power consumption, offering all required flexibility
for a state of the art AM transceiver base station.
An external coil (L), and capacitor (C) are
connected as a parallel resonant circuit, that
determines the carrier frequency and the oscillator
frequency of the reader. This eliminates zero
modulation effects by perfect antenna tuning, and
avoids the need for an external oscillator.
The reader IC can easily be switched to power
down by setting the antenna amplitude to zero.
The MLX90109 can be configured to decode the
transponder signal on-chip. In this case the
decoded signal is available through a 2-wire
interface with clock and data. For minimum
interface wiring, the non-decoded transponder
signal can also be made available on a single wire
interface.
3901090109
Rev 008
Page 1 of 15
Data Sheet
Jun/06