ODLC-65 Datasheet, PDF (2/6 Pages) Mean Well Enterprises Co., Ltd. – CONSTANT CURRENT MODE OUTPUT

65W Constant Current Mode LED Driver
ODLC-65 series
SPECIFICATION
MODEL
ODLC-65 -700
ODLC-65 -1050
ODLC-65 -1400
ODLC-65 -1750
RATED CURRENT
700mA
1050mA
1400mA
RATED POWER
65.1W
65.1W
64.4W
CONSTANT CURRENT REGION Note.2 69 ~ 93V
46 ~ 62V
34 ~ 46V
OUTPUT ^{OPEN CIRCUIT VOLTAGE(max.) 118V}
82V
60V
CURRENT RIPPLE
5% max. @rated current
CURRENT TOLERANCE ±7.0%
SETUP TIME Note.4
500ms / 230VAC
AUXILIARY DC OUTPUT Note.5 Nominal 12V(deviation 11.4~12.6)@50mA for A-Type only
VOLTAGE RANGE Note.3 ^{180 ~ 295VAC}
254 ~ 417VDC
(Please refer to "STATIC CHARACTERISTIC" section)
FREQUENCY RANGE
47 ~ 63Hz
1750mA
63W
27 ~ 36V
53V
POWER FACTOR (Typ.)
PF>0.95/230VAC, PF>0.9/277VAC@full load
(Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
INPUT
TOTAL HARMONIC DISTORTION
THD< 20%(@load≧75%/230VAC,277VAC)
(Please refer to “TOTAL HARMONIC DISTORTION” section)
EFFICIENCY (Typ.)
88%
86%
85%
85%
AC CURRENT
0.4A/230VAC 0.3A/277VAC
INRUSH CURRENT (Typ.) COLD START 30A(twidth=100μs measured at 50% Ipeak) at 230VAC; Per NEMA 410
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
32 units (circuit breaker of type B) / 32 units (circuit breaker of type C) at 230VAC
LEAKAGE CURRENT
<0.75mA / 277VAC
NO LOAD POWER CONSUMPTION <0.5W for Blank-Type, <1.2W for A-Type
PROTECTION SHORT CIRCUIT
Hiccup mode, re-power on to recovery
WORKING TEMP.
Tcase=-20 ~ +85℃ (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)
MAX. CASE TEMP.
Tcase=+85℃
WORKING HUMIDITY
20 ~ 90% RH non-condensing
ENVIRONMENT _{STORAGE TEMP., HUMIDITY -40 ~ +80℃, 10 ~ 95% RH}
TEMP. COEFFICIENT
±0.03%/℃ (0 ~ 45℃)
VIBRATION
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS
UL8750;CSA C22.2 NO.250.13-12; ENEC EN61347-1 & EN61347-2-13 independent, EN62384,
GB19510.1,GB19510.14; IP67 approved
WITHSTAND VOLTAGE
SAFETY &
EMC
ISOLATION RESISTANCE
EMC EMISSION
I/P-O/P:3.75KVAC
I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
Compliance to EN55015, EN61000-3-2 Class C (≧75% load) ; EN61000-3-3,GB17743,GB17625.1
EMC IMMUNITY
Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level(surge immunity:Line-Line:1KV)
MTBF
380.7Khrs min. MIL-HDBK-217F (25℃)
OTHERS DIMENSION
121*77*28.5mm(L*W*H)
NOTE
PACKING
0.43Kg; 24pcs/ 11.3Kg/ 0.74CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25℃ of ambient temperature.
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. De-rating may be needed under low input voltages. Please refer to “STATIC CHARACTERISTIC” sections for details.
4. Length of set up time is measured at cold first start. Turning ON/OFF the driver may lead to increase of the set up time or set up failure
5. There is no design of short circuit protection for the Auxiliary DC output; this function can not be used when dimming input terminals(DIM+,DIM-)
are short circuit or when it is no load or short circuit at output(Vo+,Vo-).
6. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be
affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
File Name:ODLC-65-SPEC 2016-10-26