USP-500 Datasheet, PDF (1/4 Pages) Mean Well Enterprises Co., Ltd. – 500W Single Output with PFC Function

500W Single Output with PFC Function
USP-500 series
Features :
Universal AC input / Full range
Built in active PFC circuit compliance to EN61000-3-2
Protections: Short circuit / Overload / Over voltage / Over temperature
Free air convection for 400W and 500W with 23.5CFM forced air
High power density 6.2w/in³
AC input active surge current limiting
U-bracket low profile:41mm
Current sharing(1+1) for 24V and 48V models (Optional)
Built-in remote ON-OFF control
Built-in remote sense function
Built in DC OK active signal
SPECIFICATION
3 years warranty
..
MODEL
USP-500-5
USP-500-12
USP-500-15
USP-500-24
USP-500-48
DC VOLTAGE
5V
12V
15V
24V
48V
RATED CURRENT
80A
42A
33.5A
21A
10.5A
CURRENT RANGE (convection) 0 ~ 60A
0 ~ 33A
0 ~ 27A
0 ~ 17A
0 ~ 8.5A
CURRENT RANGE (23.5CFM FAN) 0 ~ 80A
0 ~ 42A
0 ~ 33.5A
0 ~ 21A
0 ~ 10.5A
RATED POWER (convection) 300W
396W
405W
408W
408W
RATED POWER (23.5CFM FAN) 400W
504W
502.5W
504W
504W
OUTPUT RIPPLE & NOISE (max.) Note.2 80mVp-p
VOLTAGE ADJ. RANGE
4.5 ~ 5.5V
100mVp-p
10.8 ~ 13.2V
100mVp-p
13.5 ~ 16.5V
150mVp-p
21.6 ~ 27V
150mVp-p
43.2 ~ 52.8V
VOLTAGE TOLERANCE Note.3 2.0%
2.0%
2.0%
2.0%
2.0%
LINE REGULATION
0.5%
0.5%
0.5%
0.5%
0.5%
LOAD REGULATION
2.0%
1.0%
1.0%
1.0%
1.0%
SETUP, RISE TIME
1500ms, 80ms/230VAC 3100ms, 80ms/115VAC at full load
HOLD UP TIME (Typ.)
20ms/230VAC 20ms/115VAC at full load
VOLTAGE RANGE Note.5 90 ~ 264VAC
FREQUENCY RANGE
47 ~ 63Hz
127 ~ 370VDC
POWER FACTOR (Typ.)
0.95/230VAC 0.98/115VAC at full load
INPUT EFFICIENCY (Typ.)
85%
90%
90%
89%
90%
AC CURRENT (Typ.)
6A/115VAC 2.6A/230VAC
INRUSH CURRENT (Typ.) 30A/115VAC 50A/230VAC
LEAKAGE CURRENT
<2mA / 240VAC
OVERLOAD
PROTECTION ^{OVER VOLTAGE}
105 ~ 130% rated output power
Protection type : Constant current limiting, unit will shut down after 3 sec. ,re-power on to recover
5.7 ~ 7V
13.5 ~ 16V
17 ~ 21V
27.8 ~ 32.4V
Protection type : Shut down o/p voltage, re-power to recover
85 5 (TSW1 : detect on heatsink of o/p diode)
53 ~ 64.8V
OVER TEMPERATURE
95 5 (5V),100 (12V,15V,24V,48V) (TSW2 : detect on heatsink of power transistor)
Protection type : Shut down o/p voltage with auto-recovery
FUNCTION ^{REMOTE ON/OFF CONTROL}
DC-OK SIGNAL
RC+/RC-: 0~0.8V power on ; 4~10V power off
PSU turn on : 3.3V ~ 5.6V ; PSU turn off: 0 ~ 1V
WORKING TEMP.
-20 ~ +70 (Refer to output load derating curve)
WORKING HUMIDITY
20 ~ 90% RH non-condensing
ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85 , 10 ~ 95% RH
TEMP. COEFFICIENT
0.03%/ (0 ~ 50 )
VIBRATION
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
SAFETY STANDARDS
UL60950-1, TUV EN60950-1 approved
SAFETY &
EMC
(Note 4)
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
EMI CONDUCTION & RADIATION
HARMONIC CURRENT
I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC 25 70%RH
Compliance to EN55022 (CISPR22) Class B
Compliance to EN61000-3-2,-3
EMS IMMUNITY
Compliance to EN61000-4-2,3,4,5,6,8,11, ENV50204, EN55024, EN61000-6-2, heavy industry level, criteria A
MTBF
129.8K hrs min. MIL-HDBK-217F (25 )
OTHERS DIMENSION
PACKING
254*127*41mm (L*W*H)
1.6Kg; 6pcs/10.6Kg/0.67CUFT
NOTE
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
5. Derating may be needed under low input voltages. Please check the derating curve for more details.
File Name:USP-500-SPEC 2007-09-19