SE-1000_11 Datasheet, PDF (1/3 Pages) Mean Well Enterprises Co., Ltd. – 1000W Single Output Power Supply

1000W Single Output Power Supply
SE-1000 series
Features :
AC input active surge current limiting
AC input range selected by switch
Protections: Short circuit / Overload / Over voltage / Over temperature
Forced air cooling by built-in DC ball bearing fan
High power density 7.3w/inch³
With DC_OK signal output
Built-in remote ON-OFF control
Built-in remote sense function
UL / CUL approved
Low cost
2 years warranty
SPECIFICATION
MODEL
SE-1000-5
SE-1000-9
SE-1000-12
SE-1000-15
SE-1000-24
SE-1000-48
DC VOLTAGE
5V
9V
12V
15V
24V
48V
RATED CURRENT
CURRENT RANGE
150A
0 ~ 150A
100A
0 ~ 100A
83.3A
0 ~ 83.3A
66.7A
0 ~ 66.7A
41.7A
0 ~ 41.7A
20.8A
0 ~ 20.8A
RATED POWER
750W
900W
999.6W
1000.5W
1000.8W
998.4W
RIPPLE & NOISE (max.) Note.2 150mVp-p
150mVp-p
150mVp-p
150mVp-p
200mVp-p
200mVp-p
OUTPUT
VOLTAGE ADJ. RANGE
3.3 ~ 5.5V
VOLTAGE TOLERANCE Note.3 1.0%
LINE REGULATION
0.5%
7.5 ~ 10V
1.0%
0.5%
10 ~ 13.5V
1.0%
0.5%
13.5 ~ 16.5V
1.0%
0.5%
22 ~ 27.5V
1.0%
0.5%
43 ~ 56V
1.0%
0.5%
LOAD REGULATION
1.0%
0.5%
0.5%
0.5%
0.5%
0.5%
SETUP, RISE TIME
1500ms, 50ms/230VAC 1500ms, 50ms/115VAC at full load
HOLD UP TIME (Typ.)
20ms/230VAC 15ms/115VAC at full load
VOLTAGE RANGE
90 ~ 132VAC / 180 ~ 264VAC selected by TB2 254 ~ 370VDC
FREQUENCY RANGE
47 ~ 63Hz
EFFICIENCY (Typ.)
81%
84%
85%
86%
88%
89%
INPUT
AC CURRENT (Typ.)
17.5A/115VAC 10A/230VAC
INRUSH CURRENT (Typ.) 35A/115VAC 55A/230VAC
LEAKAGE CURRENT
<2.5mA / 240VAC
OVERLOAD
105 ~ 125% rated output power
Protection type : Shut down o/p voltage, re-power on to recover
PROTECTION OVER VOLTAGE
5.75 ~ 6.3V
10.4 ~ 12.2V
13.8 ~ 16.2V
18 ~ 21V
Protection type : Shut down o/p voltage, re-power on to recover
28 ~ 32.4V
57.6 ~ 67.2V
OVER TEMPERATURE
70 5 (TSW1) detect on heatsink of power transistor
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
DC_OK SIGNAL
FUNCTION
REMOTE CONTROL
PSU turn on:3.3V ~ 5.6V PUS turn off:0 ~ 1V
RC+/RC-: 0 ~ 0.8V power on; 4 ~ 10V power off
WORKING TEMP.
-20 ~ +60 (Refer to "Derating Curve")
WORKING HUMIDITY
20 ~ 90% RH non-condensing
ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85 , 10 ~ 95% RH
TEMP. COEFFICIENT
0.05%/ (0 ~ 50 )
VIBRATION
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
SAFETY STANDARDS
UL60950-1 approved
SAFETY WITHSTAND VOLTAGE
I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH
MTBF
251.6K hrs min. MIL-HDBK-217F (25 )
OTHERS DIMENSION
278*127*63.5mm (L*W*H)
PACKING
2.5Kg; 6pcs/16Kg/1.38CUFT
NOTE
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. By using UVP circuit, PSU will not turn on direct by in AC continue ON/OFF condition within 5 sec.
File Name:SE-1000-SPEC 2011-08-23