RSP-1500_10 Datasheet, PDF (1/4 Pages) Mean Well Enterprises Co., Ltd. – 1500W Single Output Power Supply

1500W Single Output Power Supply
RSP-1500 series
Features :
Universal AC input/Full range
ZVS new technology
AC input active surge current limiting
High efficiency up to 91%
Built-in active PFC function,PF>0.95
Protections: Short circuit / Overload / Over voltage / Over temperature
Forced air cooling by built-in DC ball bearing fan
Output voltage can be trimmed between 70~100% of the rated output voltage
High power density 8.3W/inch³
Current sharing up to 6000W(3+1)
Alarm signal output
Built-in 12V/0.1A auxiliary output for remote control
Built-in remote ON-OFF control
Built-in remote sense function
3 years warranty
SPECIFICATION
MODEL
RSP-1500-5
RSP-1500-12
RSP-1500-15
RSP-1500-24
RSP-1500-27
RSP-1500-48
DC VOLTAGE
5V
12V
15V
24V
27V
48V
RATED CURRENT
240A
125A
100A
63A
56A
32A
CURRENT RANGE
0 ~ 240A
0 ~ 125A
0 ~ 100A
0 ~ 63A
0 ~ 56A
0 ~ 32A
RATED POWER
1200W
1500W
1500W
1512W
1512W
1536W
OUTPUT
RIPPLE & NOISE (max.) Note.2 150mVp-p
VOLTAGE ADJ. RANGE
4.5 ~ 5.5V
VOLTAGE TOLERANCE Note.3 2.0%
150mVp-p
10 ~ 13.5V
1.0%
150mVp-p
13.5 ~ 16.5V
1.0%
150mVp-p
20 ~ 26.4V
1.0%
150mVp-p
24 ~ 30V
1.0%
200mVp-p
43 ~ 56V
1.0%
LINE REGULATION
0.5%
0.5%
0.5%
0.5%
0.5%
0.5%
LOAD REGULATION
2.0%
0.5%
0.5%
0.5%
0.5%
0.5%
SETUP, RISE TIME
1500ms, 100ms at full load
HOLD UP TIME (Typ.)
10ms at full load
14ms at full load
16ms at full load
VOLTAGE RANGE
90 ~ 264VAC 127 ~ 370VDC
FREQUENCY RANGE
47~63Hz
POWER FACTOR (Typ.)
0.95/230VAC 0.98/115VAC at full load
INPUT EFFICIENCY (Typ.)
80%
87%
87%
90%
90%
91%
AC CURRENT (Typ.)
INRUSH CURRENT (Typ.)
17A/115VAC
30A/115VAC
8A/230VAC
60A/230VAC
LEAKAGE CURRENT
<2.0mA / 240VAC
OVERLOAD
105 ~135% rated output power
Note.5 _{Protection type : Constant current limiting unit will shut down o/p voltage after 5sec. Re-power on to recover}
PROTECTION OVER VOLTAGE
5.75 ~ 6.75V
13.8 ~ 16.8V
17 ~ 20.5V
27.6 ~ 32.4V
Protection type : Shut down o/p voltage, re-power on to recover
31 ~ 36.5V
OVER TEMPERATURE
95 5 (TSW2 ) detect on heatsink of power transistor
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
AUXILIARY POWER(AUX) ^{12V@0.1A(Only for Remote ON/OFF control)}
REMOTE ON/OFF CONTROL ^{Please see the Function Manual}
FUNCTION ALARM SIGNAL OUTPUT ^{Please see the Function Manual}
OUTPUT VOLTAGE TRIM Please see the Function Manual
CURRENT SHARING
Please see the Function Manual
WORKING TEMP.
-20 ~ +70 (Refer to output load derating curve)
WORKING HUMIDITY
20~90% RH non-condensing
ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85 , 10 ~ 95% RH
57.6 ~ 67.2V
SAFETY &
EMC
(Note 4)
TEMP. COEFFICIENT
0.05%/ (0 ~ 50 )
VIBRATION
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
SAFETY STANDARDS
UL60950-1, TUV EN60950-1 approved
WITHSTAND VOLTAGE
I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH
EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22)
HARMONIC CURRENT
Compliance to EN61000-3-2,-3
OTHERS
NOTE
EMS IMMUNITY
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, light industry level, criteria A
MTBF
62.6K hrs min. MIL-HDBK-217F (25 )
DIMENSION
278*127*83.5mm (L*W*H)
PACKING
3.0Kg; 4pcs/13Kg/1.19CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies.”
(as available on http://www.meanwell.com)
5. Derating may be needed under low input voltages. Please check the derating curve for more details.
File Name:RSP-1500-SPEC 2010-10-18