PCD-25 Datasheet, PDF (1/3 Pages) Mean Well Enterprises Co., Ltd. – 25W Single Output AC Dimmable LED Power Supply

25W Single Output AC Dimmable LED Power Supply
PCD-25 series
Features :
AC phase-cut dimming
Work with leading edge and trailing edge dimmers
115VAC or 230VAC models available
Fully isolated plastic case
Constant current design
Protections: Short circuit / Overload / Over temperature
Built-in active PFC function
Cooling by free air convection
Suitable for indoor LED lighting applications
100% full load burn-in test
Low cost
High reliability
3 years warranty
SELV
( for A type only)
PCD-25-350 A A : With AC input 90~ 135VAC.
B : With AC input 180~ 295VAC.
SPECIFICATION
MODEL
PCD-25-350
PCD-25-700
PCD-25-1050
PCD-25-1400
RATED CURRENT
350mA
700mA
1050mA
1400mA
OPERATING VOLTAGE RANGE 40 ~ 58V
24 ~ 36V
16 ~ 24V
12 ~ 18V
CURRENT RANGE
0 ~ 350mA
0 ~ 700mA
0 ~ 1050mA
0 ~ 1400mA
OUTPUT RATED POWER
20.3W
25.2W
25.2W
25.2W
RIPPLE & NOISE (max.) Note.1 4.6Vp-p
2.7Vp-p
NO LOAD OUTPUT VOLTAGE (max.) 63V
50V
SETUP TIME
1000ms / 230VAC 2000ms / 115VAC at full load
2.2Vp-p
35V
2Vp-p
25V
FREQUENCY RANGE
47 ~ 63Hz
POWER FACTOR
PF 0.9 at full load and rated output voltage
INPUT
EFFICIENCY(Typ.)
AC CURRENT
INRUSH CURRENT(max.)
82%
81%
0.6A/115VAC 0.3A/230VAC
40A/230VAC
80.5%
80%
LEAKAGE CURRENT
<0.5mA / 240VAC
OVER CURRENT
95 ~ 110%
Protection type : Constant current limiting, recovers automatically after fault condition is removed
PROTECTION SHORT CIRCUIT
OVER TEMPERATURE
Hiccup mode, recovers automatically after fault condition is removed.
95 10 (TSW1) detect on heatsink of power transistor
Protection type : Shut down o/p voltage
WORKING TEMP.
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
-30 ~ +60 (Refer to output load derating curve)
20 ~ 95% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH
0.03%/ (0 ~ 50 )
VIBRATION
10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes
SAFETY STANDARDS
TUV EN61347-1, EN61347-2-13 approved ; Design refer to UL1310 Class 2
WITHSTAND VOLTAGE
I/P-O/P:3.75KVAC
SAFETY & ISOLATION RESISTANCE _{I/P-O/P:100M Ohms / 500VDC / 25 / 70% RH}
EMC
EMI CONDUCTION & RADIATION Compliance to EN55015 Class B (B type only), FCC part18 Class A (A type only)
HARMONIC CURRENT
Compliance to EN61000-3-2 Class C ; EN61000-3-3
EMS IMMUNITY
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024,EN61547, light industry level, criteria A
MTBF
906.5Khrs min. MIL-HDBK-217F (25 )
OTHERS DIMENSION
84*57*29.5mm (L*W*H)
PACKING
0.19Kg; 72pcs/14.7Kg/0.92CUFT
NOTE
1. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
2. Direct connecting to LEDs is not using additional drivers is highly recommended.
( for B type only)
File Name:PCD-25-SPEC 2011-03-09