LPL-18_1111 Datasheet, PDF (1/2 Pages) Mean Well Enterprises Co., Ltd. – 18W Single Output Switching Power Supply

18W Single Output Switching Power Supply
LPL-18 series
Features :
90-132VAC input only
Fully encapsulated with IP67 level (Note.5)
Protections:Short circuit/Over load/Over voltage/Over temperature
Cooling by free air convection
Class power unit, no FG
Pass LPS
100% full load burn-in test
Suitable for LED lighting and moving sign applications
High reliability/Low cost
2 years warranty
SPECIFICATION
LPS IP67
(LVD)
MODEL
LPL-18-12
LPL-18-24
LPL-18-36
DC VOLTAGE
12V
24V
36V
RATED CURRENT
1.5A
0.75A
0.5A
CURRENT RANGE
0 ~ 1.5A
0 ~ 0.75A
0 ~ 0.5A
RATED POWER
18W
18W
18W
OUTPUT
RIPPLE & NOISE (max.) Note.2 120mVp-p
VOLTAGE TOLERANCE Note.3 3.0%
LINE REGULATION
1.0%
150mVp-p
200mVp-p
LOAD REGULATION
2.0%
SETUP, RISE TIME
1500ms, 30ms / 115VAC
HOLD UP TIME (Typ.)
20ms/115VAC at full load
VOLTAGE RANGE
90 ~ 132VAC 127 ~ 186VDC
FREQUENCY RANGE
47 ~ 63Hz
EFFICIENCY(Typ.)
80%
83%
84%
INPUT
AC CURRENT
0.5A/115VAC
INRUSH CURRENT(max.) Cold start 40A/115VAC
LEAKAGE CURRENT
0.25mA / 115VAC
OVER LOAD
Above 105% rated output power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
PROTECTION OVER VOLTAGE
13.8~ 16.2V
27.6~ 32.4V
Protection type : Shut off o/p voltage, clamping by zener diode
41.4 ~ 48.6V
OVER TEMPERATURE
Tj 140 typically (U1) detect on main control IC
Protection type :Shut down, recovers automatically after temperature goes down
WORKING TEMP.
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
-30~ +70 (Refer to "Derating Curve")
20 ~ 90% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH
0.03%/ (0 ~ 50 )
VIBRATION
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS
IP67 approved; design refer to UL1310 Class 2,TUV EN60950-1, EN61347-2-13, CAN/CSA C22.2 No. 223-M91
SAFETY &
EMC
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
EMC EMISSION
EMC IMMUNITY
I/P-O/P:3KVAC
I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH
Compliance to EN55022 (CISPR22) Class B, FCC Part 15, EN61000-3-2 Class A, EN61000-3-3
Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A
OTHERS
NOTE
MTBF
1207.4Khrs min. MIL-HDBK-217F(25 )
DIMENSION
140*30*22(L*W*H)
PACKING
0.175Kg; 70pcs/13.3Kgs/0.71CUFT
1. All parameters NOT specially mentioned are measured at 115VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
5. Suitable for indoor use or outdoor use without direct sunlight exposure.
File Name: LPL-18-SPEC 2011-11-08