LPH-18_1107 Datasheet, PDF (1/2 Pages) Mean Well Enterprises Co., Ltd. – 18W Single Output Switching Power Supply

18W Single Output Switching Power Supply
LPH-18 series
■ Features :
180-264VAC input only
Fully encapsulated with IP67 level (Note.5)
Protections:Short circuit / Over current / Over voltage / Over temperature
Cooling by free air convection
Pass LPS
100% full load burn-in test
Suitable for LED lighting and moving sign applications
SPECIFICATION
High reliability / Low cost
2 years warranty
LPS IP67 ^..
MODEL
LPH-18-12
LPH-18-24
LPH-18-36
DC VOLTAGE
12V
24V
36V
RATED CURRENT
1.5A
0.75A
0.5A
CURRENT RANGE
0 ~ 1.5A
0 ~ 0.75A
0 ~ 0.5A
RATED POWER
18W
18W
18W
OUTPUT
RIPPLE & NOISE (max.) Note.2 120mVp-p
VOLTAGE TOLERANCE Note.3 ± 3.0%
LINE REGULATION
± 1.0%
150mVp-p
200mVp-p
LOAD REGULATION
± 2.0%
SETUP, RISE TIME
1500ms, 30ms / 230VAC
HOLD UP TIME (Typ.)
50ms/230VAC at full load
VOLTAGE RANGE
180 ~ 264VAC 254 ~ 370VDC
FREQUENCY RANGE
47 ~ 63Hz
EFFICIENCY(Typ.)
78%
82%
83%
INPUT
AC CURRENT
0.3A/230VAC
INRUSH CURRENT(max.) Cold start 50A/230VAC
LEAKAGE CURRENT
0.25mA / 240VAC
OVER CURRENT
PROTECTION OVER VOLTAGE
Above 105% rated output power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
13.8~ 16.2V
27.6~ 32.4V
Protection type : Shut off o/p voltage, clamping by zener diode
41.4 ~ 48.6V
OVER TEMPERATURE
Tj 170℃ typically (U1) Detect on main control IC
Protection type : Hiccup mode, recovers automatically after temperature goes down
WORKING TEMP.
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
-30~ +70℃ (Refer to "Derating Curve")
20 ~ 90% RH non-condensing
-40 ~ +80℃, 10 ~ 95% RH
± 0.03%/℃ (0 ~ 50℃)
VIBRATION
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS
SAFETY & _{WITHSTAND VOLTAGE}
EMC
(Note 4)
ISOLATION RESISTANCE
EMC EMISSION
EMC IMMUNITY
TUV EN60950-1, IP67 approved; design refer to UL1310 Class 2,EN61347-2-13, CAN/CSA C22.2 No. 223-M91
I/P-O/P:3KVAC
I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
Compliance to EN55022 (CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3
Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A
OTHERS
NOTE
MTBF
1200.6K hrs min. MIL-HDBK-217F (25℃)
DIMENSION
140*30*22(L*W*H)
PACKING
0.175Kg; 70pcs/13.3Kgs/0.71CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
5. Suitable for indoor use or outdoor use without direct sunlight exposure.
File Name: LPH-18-SPEC 2011-07-08