LPC-150 Datasheet, PDF (1/2 Pages) Mean Well Enterprises Co., Ltd. – 150W Single Output LED Power Supply

150W Single Output LED Power Supply
LPC-150 series
■ Features :
Constant current design
180~305VAC input only
High efficiency up to 90%
Protections: Short circuit / Over voltage / Over temperature
Cooling by free air convection
Fully encapsulated with IP67 level (Note.6)
Fully isolated plastic case
ClassⅡpower unit, no FG
Suitable for LED lighting and moving sign application (Note.7)
100% full load burn-in test
Low cost, high reliability
2 years warranty (Note.4)
SPECIFICATION
IP67
MODEL
LPC-150-350 LPC-150-500 LPC-150-700 LPC-150-1050 LPC-150-1400 LPC-150-1750 LPC-150-2100 LPC-150-2450 LPC-150-2800 LPC-150-3150
OUTPUT
INPUT
RATED CURRENT
350mA 500mA 700mA 1050mA 1400mA 1750mA
CURRENT ACCURACY
±5.0%
CONSTANT CURRENT REGION Note.5 215 ~ 430V 150 ~ 300V 107V ~ 215V 72V ~ 144V 54V ~ 108V 43V ~ 86V
RATED POWER
150.5W 150W
150.5W 151.2W 151.2W 150.5W
RIPPLE CURRENT
±5%
RIPPLE & NOISE
2Vp-p
1.5Vp-p 1Vp-p
1Vp-p
1Vp-p
1Vp-p
VOLTAGE TOLERANCE
±2.0%
LINE REGULATION
±1%
SETUP, RISE TIME
1000ms, 80ms / 230VAC at full load
HOLD UP TIME (Typ.)
16ms/230VAC at full load
VOLTAGE RANGE Note.2 180 ~ 305VAC 254VDC ~ 431VDC
FREQUENCY RANGE
47 ~ 63Hz
EFFICIENCY (Typ.)
90%
AC CURRENT (Typ.)
INRUSH CURRENT (Typ.)
1.7 A / 230VAC
1.5A / 277VAC
COLD START 40A(twidth=750μs measured at 50% Ipeak) at 230VAC
2100mA 2450mA 2800mA 3150mA
36V ~ 72V 31V ~ 62V 27V ~ 54V 24V ~ 48V
151.2W 151.9W 151.2W 151.2W
1Vp-p
1Vp-p
1Vp-p
1Vp-p
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
3 units (circuit breaker of type B) / 6 units (circuit breaker of type C) at 230VAC
LEAKAGE CURRENT
<0.25mA / 277VAC
SHORT CIRCUIT
Hiccup mode, recovers automatically after fault condition is removed
PROTECTION _{OVER VOLTAGE}
440 ~ 470V 330 ~ 365V 235 ~ 265V 158 ~ 188V 115 ~ 135V 96 ~ 115V 80 ~ 97V
Protection type : Shut down and latch off o/p voltage re-power on to recovery
69 ~ 80V
63 ~ 75V
55 ~ 65V
OVER TEMPERATURE
Shut down o/p voltage, recovers automatically after temperature goes down
WORKING TEMP.
-25 ~ +50℃ (Refer to "Derating Curve")
WORKING HUMIDITY
10 ~ 95% RH non-condensing
ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +70℃, 10 ~ 95% RH
TEMP. COEFFICIENT
±0.03%/℃ (0 ~ 50℃)
VIBRATION
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS
IP67 approved; refer to EN60950-1
WITHSTAND VOLTAGE
SAFETY &
ISOLATION RESISTANCE
EMC
EMC EMISSION
I/P-O/P:3KVAC
I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
Compliance to EN55022(CISPR22) Class B; EN61000-3-2 Class A(≤80% load); EN61000-3-3
EMC IMMUNITY
Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level , criteria A
MTBF
479K hrs min. MIL-HDBK-217F (25℃)
OTHERS DIMENSION
191*63*37.5mm (L*W*H)
NOTE
PACKING
0.74Kg; 20pcs/15.8Kg/0.95CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
2. Derating may be needed under low input voltages. Please check the static characteristics for more details.
3. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
4. Refer to warranty statement.
5. Constant current operation region is within 50% ~100% rated output voltage. This is the suitable operation region for LED related applications, but please
reconfirm special electrical requirements for some specific system design.
6. Suitable for indoor use or outdoor use without direct sunlight exposure, please avoid immerse in the water over 30minutes.
7. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
File Name:LPC-150-SPEC 2015-05-28