HLG-60H-C Datasheet, PDF (1/6 Pages) Mean Well Enterprises Co., Ltd. – 70W Single Output LED Power Supply

70W Single Output LED Power Supply
HLG-60H-C series
¡½ Features :
¡EConstant current design
¡EUniversal AC input / Full range (up to 305VAC)
¡EBuilt-in active PFC function
¡EHigh efficiency up to 91%
¡EProtections: Short circuit / Over voltage / Over temperature
¡ECooling by free air convection
¡EOutput current adjustable through output cable or internal potentiometer
¡EIP67 / IP65 design for indoor or outdoor installations
¡EThree in one dimming function (1~10Vdc or 10V PWM signal or resistance)
¡ESuitable for dry / damp / wet locations
¡E5 years warranty (Note.5)
F ¹¹⁰ M M _{IP65 IP67}
HLG-60H-C350 A A : IP65 rated. Constant current level can be adjusted through internal potentiometer.
B : IP67 rated. Constant current level adjustable through output cable with 1~10Vdc or 10V PWM signal or resistance.
D (option) : IP67 rated. Timer dimming function, contact MEAN WELL for details.
SPECIFICATION
MODEL
HLG-60H-C350
HLG-60H-C700
RATED CURRENT
CURRENT ACCURACY
350mA
¡Ó5.0%
700mA
OUTPUT
CONSTANT CURRENT REGION Note.6 100 ~ 200V
50 ~ 100V
RATED POWER
70W
70W
RIPPLE CURRENT
¡Ó5%
RIPPLE & NOISE
Note.7 1V
0.5V
CURRENT ADJ. RANGE
Can be adjusted by internal potentiometer or through output cable
210 ~ 350mA
420 ~ 700mA
SETUP, RISE TIME
1500ms, 80ms / 115VAC at full load 1000ms, 80ms / 230VAC at full load
HOLD UP TIME (Typ.)
16ms at full load 230VAC / 115VAC
VOLTAGE RANGE Note.2 90 ~ 305VAC
FREQUENCY RANGE
47 ~ 63Hz
127VDC ~ 431VDC
INPUT
POWER FACTOR (Typ.)
EFFICIENCY (Typ.)
AC CURRENT (Typ.)
INRUSH CURRENT (Typ.)
PF>0.98/115VAC, PF>0.96/230VAC, PF>0.94/277VAC at full load (Please refer to "Power Factor Characteristic" curve)
91%
91%
0.69A / 115VAC 0.35A / 230VAC 0.29A / 277VAC
COLD START 70A / 230VAC
LEAKAGE CURRENT
<0.75mA / 277VAC
SHORT CIRCUIT
PROTECTION ^{OVER VOLTAGE}
OVER TEMPERATURE
WORKING TEMP.
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
Hiccup mode, recovers automatically after fault condition is removed
230 ~ 250V
120 ~ 140V
Protection type : Shut down o/p voltage with auto-recovery or re-power on to recovery
85¢J¡Ó10¢J (RTH2)
Protection type : Shut down o/p voltage, re-power on to recover
¢J -40 ~ +70 (Refer to "Derating Curve")
10 ~ 95% RH non-condensing
¢J -40 ~ +80 , 10 ~ 95% RH
¡Ó ¢J ¢J 0.03%/ (0 ~ 50 )
VIBRATION
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
SAFETY STANDARDS Note.3 UL8750, CSA C22.2 No. 250.0-08, EN61347-1, EN61347-2-13 independent, IP65 or IP67 approved
WITHSTAND VOLTAGE
SAFETY &
ISOLATION RESISTANCE
EMC
EMC EMISSION
I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC
¢J I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH
¡Ù Compliance to EN55015, EN61000-3-2 Class C ( 60% load) ; EN61000-3-3
OTHERS
NOTE
EMC IMMUNITY
MTBF
Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, heavy industry level (surge L,N-FG: 4KV), criteria A
¢J 338K hrs min. MIL-HDBK-217F (25 )
DIMENSION
171*61.5*36.8 mm (L*W*H)
¢J ^PACKING
0.73Kg; 20pcs/15.6Kg/0.8CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Derating may be needed under low input voltages. Please check the static characteristics for more details.
3. Safety and EMC design refer to EN60598-1, CNS15233, GB7000.1.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
5. Refer to warranty statement.
6. Constant current operation region is within 50% ~100% rated output voltage. This is the suitable operation region for LED related applications, but please
reconfirm special electrical requirements for some specific system design.
7. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 2.2uf parallel capacitor.
File Name:HLG-60H-C-SPEC 2012-05-25
MeanWell Direct Tel: [phone] E-mail: [e-mail]