GS05E-USB Datasheet, PDF (1/3 Pages) Mean Well Enterprises Co., Ltd. – 5WAC-DC Single Output Wall-mounted type

5W AC-DC Single Output Wall-mounted type
GS05E-USB
SPECIFICATION
¡½ Features :
¡EUniversal AC input / Full range
¡ENo load power consumption <0.3W
¡ECompact size
¡EErP step2 compliant
¡E2 pole Euro plug
¡EClass II power (without earth pin)
¡EProtections: Short circuit / Overload / Over voltage / Over temperature
¡EPass LPS
¡E100% full load burn-in test
¡EFully enclosed plastic case
¡ELow cost, high reliability
¡E2 years warranty
MODEL NO.
GS05E-USB
DC VOLTAGE
Note.2 5V
RATED CURRENT
1.00A
CURRENT RANGE
0 ~ 1.00A
RATED POWER
5W
OUTPUT
RIPPLE & NOISE (max.) Note.3 80mVp-p
¡Ó VOLTAGE TOLERANCE Note.4 4.0%
¡Ó LINE REGULATION Note.5 1.0%
¡Ó LOAD REGULATION Note.6 4.0%
SETUP, RISE, HOLD UP TIME 300ms, 20ms, 50ms at full load
VOLTAGE RANGE
90 ~ 264VAC 127 ~ 370VDC
FREQUENCY RANGE
47 ~ 63Hz
INPUT
EFFICIENCY (Typ.)
AC CURRENT
Note.7 71%
0.15A / 100VAC
INRUSH CURRENT (max.) 30A / 230VAC
LEAKAGE CURRENT(max.) 0.25mA / 240VAC
OVERLOAD
105 ~ 135% rated output voltage power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
PROTECTION OVER VOLTAGE
OVER TEMPERATURE
WORKING TEMP.
105 ~ 200% rated output voltage, detect on main control IC
Protection type : Hiccup mode, recovers automatically after fault condition is removed
¢J U1 Tj 142 typically (U1) detect on main control IC
¢J ^{Protection type : Shut down o/p voltage, recovers automatically after temperature goes down}
-20 ~ +50 (Refer to "Derating curve")
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
20% ~ 90% RH non-condensing
¢J -20 ~ +85 , 10 ~ 95% RH
¡Ó ¢J ¢J 0.03% / (0 ~ 50 )
VIBRATION
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS
TUV EN60950-1 approved
SAFETY & ^{WITHSTAND VOLTAGE}
EMC
ISOLATION RESISTANCE
(Note. 8) _{EMC EMISSION}
I/P-O/P:4242VDC
¢J I/P-O/P:100M Ohms / 500VDC / 25 / 70% RH
Compliance to EN55022 Class B, EN61000-3-2,3
EMC IMMUNITY
MTBF
Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A
¢J 1100Khrs min. MIL-HDBK-217F(25 )
OTHERS DIMENSION
41.54*30.5*20mm (L*W*H)
PACKING
60g
DC OUTPUT CONNECTOR
USB Type A
NOTE
¢J 1.All parameters are specified at 230VAC input, rated load, 25 70% RH ambient.
2.DC voltage: The output voltage set at point measure by plug terminal & 50% load.
3.Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor.
4.Tolerance: includes set up tolerance, line regulation, load regulation.
5.Line regulation is measured from low line to high line at rated load.
6.Load regulation is measured from 0% to 100% rated load
7.Efficiency is measured at 230VAC.
8.The power supply is considered as an independent unit, but the final equipment still need to re-confirm that the whole system complies with the
EMC directives.
File Name:GS05E-USB-SPEC 2012-10-01