MDT10P57 Datasheet, PDF (1/13 Pages) Micon Design Technology Corporation – 8-bit micro-controller

MDT10P57
1. General Description
Power-on Reset
This EPROM-Based 8-bit micro-controller uses
Power edge-detector Reset
a fully static CMOS technology process to
Sleep Mode for power saving
achieve higher speed and smaller size with the
5 types of oscillator can be selected by
low power consumption and high noise
programming option:
immunity. On chip memory includes 1K words
INRC—Internal 4MHz RC oscillator
of ROM, and 128 bytes of static RAM.
RC—Low cost RC oscillator
LFXT—Low frequency crystal
2. Features
oscillator
The followings are some of the features on the
XTAL—Standard crystal oscillator
hardware and software:
HFXT—High frequency crystal
Fully CMOS static design
oscillator
8-bit data bus
8-bit real time clock/counter (RTCC) with
On chip EPROM size: 1K words
8-bit programmable prescaler
Internal RAM size: 128 bytes
On-chip RC oscillator based Watchdog
35 single word instructions
Timer (WDT)
14-bit instructions
4-channel, 8-bit AD
8-level stacks
Interrupt source:
Operating voltage: 2.5 V ~ 5.5 V
Timer0, INT, Pin change, AD
Operating frequency: 0 ~ 20 MHz
The most fast execution time is 200 ns 3. Applications
under 20 MHz in all single cycle
The application areas range from appliance
instructions except the branch
motor control and high speed automotive to
instruction
low power remote transmitters/receivers, small
Addressing modes include direct,
instruments, chargers, toy, automobile and PC
indirect and relative addressing modes pe-ripheral … etc.
This specification are subject to be changed without notice. Any latest information please preview
http;//www.mdtic.com.tw
P. 1
2007/4 Ver. 1.1