English
Language : 

MX29LV160CT Datasheet, PDF (8/66 Pages) Macronix International – 16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY
MX29LV160C T/B
QUERY COMMAND AND COMMON FLASH
INTERFACE (CFI) MODE
MX29LV160C T/B is capable of operating in the CFI mode.
This mode all the host system to determine the manu-
facturer of the device such as operating parameters and
configuration. Two commands are required in CFI mode.
Query command of CFI mode is placed first, then the
Reset command exits CFI mode.These are described in
Table 4.
The single cycle Query command is valid only when the
device is in the Read mode, including Erase Suspend,
Standby mode, and Automatic Select mode; however, it
is ignored otherwise.
The Reset command exits from the CFI mode to the
Read mode, or Erase Suspend mode, or Automatic Se-
lect mode. The command is valid only when the device
is in the CFI mode.
Table 4-1. CFI mode: Identification Data Values
(All values in these tables are in hexadecimal)
Description
Address
(Byte Mode)
Query-unique ASCII string "QRY"
20
22
24
Primary vendor command set and control interface ID code
26
28
Address for primary algorithm extended query table
2A
2C
Alternate vendor command set and control interface ID code (none)
2E
30
Address for secondary algorithm extended query table (none)
32
34
Address
(Word Mode)
10
11
12
13
14
15
16
17
18
19
1A
Data
0051
0052
0059
0002
0000
0040
0000
0000
0000
0000
0000
Table 4-2. CFI Mode: System Interface Data Values
(All values in these tables are in hexadecimal)
Description
Address
(Byte Mode)
VCC supply, minimum (2.7V)
36
VCC supply, maximum (3.6V)
38
VPP supply, minimum (none)
3A
VPP supply, maximum (none)
3C
Typical timeout for single word/byte write (2N us)
3E
Typical timeout for Minimum size buffer write (2N us) (not supported) 40
Typical timeout for individual sector erase (2N ms)
42
Typical timeout for full chip erase (2N ms)
44
Maximum timeout for single word/byte write times (2N X Typ)
46
Maximum timeout for buffer write times (2N X Typ)
48
Maximum timeout for individual sector erase times (2N X Typ)
4A
Maximum timeout for full chip erase times (not supported)
4C
P/N:PM1186
8
Address
(Word Mode)
1B
1C
1D
1E
1F
20
21
22
23
24
25
26
Data
0027
0036
0000
0000
0004
0000
000A
0000
0005
0000
0004
0000
REV. 1.2, JAN. 19, 2006