MX25R3235F Datasheet, PDF (76/89 Pages) Macronix International – Wide Vcc Range, 32M-BIT

ADVANCED INFORMATION
MX25R3235F
High Performance Mode - Continued:
Symbol
tBP
tPP
tSE
tBE32K
tBE
tCE
Alt. Parameter
Byte-Program
Byte-Program (Applied Vhv at WP# pin)
Page Program Cycle Time
Page Program Cycle Time (Applied Vhv at WP# pin)
Sector Erase Cycle Time
Sector Erase Cycle Time (Applied Vhv at WP# pin)
Block Erase (32KB) Cycle Time
Block Erase (32KB) Cycle Time (Applied Vhv at WP# pin)
Block Erase (64KB) Cycle Time
Block Erase (64KB) Cycle Time (Applied Vhv at WP# pin)
Chip Erase Cycle Time
Chip Erase Cycle Time (Applied Vhv at WP# pin)
Min.
Typ.(2)
40
40
1.2
0.6
140
120
0.5
0.35
1
0.7
40
25
Max. Unit
100 us
100 us
2.4 ms
1.2 ms
420 ms
360 ms
1.5
s
1
s
3
s
2.1
s
120
s
75
s
Notes:
1. tCH + tCL must be greater than or equal to 1/ Frequency.
2. Typical values given for TA=25°C. Not 100% tested.
3. Only applicable as a constraint for a WRSR instruction when SRWD is set at 1.
4. For tPRS, Min. time is needed to issue next program suspend command. However, a period of time equal to/or
longer than typ. timing is also required to complete the program progress.
5. For tRES, Min. timing is needed to issue next erase suspend command. However, a period of time equal to/or
longer than typ. timing is also required to complete the erase progress.
6. If the address range is within 4Mb, the 4READ/QREAD clock rate could achieve to 16MHz for 4READ/QREAD
operation. If user wants to keep 4READ/QREAD at 16MHz for address range that is more than 4Mb, it is
necessary to re-issue 4READ/QREAD command again after each 4Mb boundary.
7. Test condition is shown as "Figure 42. Input Test Waveforms and Measurement Level", "Figure 43. Output
Loading".
8. WRSR speed max. is 33MHz when issuing WRSR for performance mode switch no matter High Performance
Mode to Low Power Mode or Low Power Mode to High Performance Mode.
9. Latency time is required to complete Erase/Program Suspend operation until WIP bit is "0".
10. The value guaranteed by characterization, not 100% tested in production.
P/N: PM2138
REV. 0.02, FEB. 06, 2015
76