MX25R1035F Datasheet, PDF (49/87 Pages) Macronix International – Wide Vcc Range, 1M-BIT

ADVANCED INFORMATION
MX25R1035F
9-22. Chip Erase (CE)
The Chip Erase (CE) instruction is for erasing the data of the whole chip to be "1". A Write Enable (WREN)
instruction must execute to set the Write Enable Latch (WEL) bit before sending the Chip Erase (CE). The CS#
must go high exactly at the byte boundary, otherwise the instruction will be rejected and not executed.
The sequence of issuing CE instruction is: CS# goes low→sending CE instruction code→CS# goes high.
The SIO[3:1] are "don't care".
The self-timed Chip Erase Cycle time (tCE) is initiated as soon as Chip Select (CS#) goes high. The Write in
Progress (WIP) bit still can be checked during the Chip Erase cycle is in progress. The WIP sets 1 during the
tCE timing, and sets 0 when Chip Erase Cycle is completed, and the Write Enable Latch (WEL) bit is reset. If the
chip is protected by BP3, BP2, BP1, BP0 bits, the Chip Erase (CE) instruction will not be executed. It will be only
executed when BP3, BP2, BP1, BP0 all set to "0".
Figure 28. Chip Erase (CE) Sequence
CS#
Mode 3
SCLK
Mode 0
SI
01234567
Command
60h or C7h
P/N: PM2218
REV. 0.00, JAN. 12, 2015
49