MAX15031_09 Datasheet, PDF (9/17 Pages) Maxim Integrated Products – 80V, 300mW Boost Converter and Current Monitor for APD Bias Applications

80V, 300mW Boost Converter and Current
Monitor for APD Bias Applications
Pin Description
PIN
NAME
FUNCTION
1
PWR
Boost Converter Input Voltage. PWR powers the switch driver and charge pump. Bypass PWR to PGND with a
ceramic capacitor of 1μF minimum value.
2
CP
Positive Terminal of the Charge-Pump Flying Capacitor for 2.7V to 5.5V Supply Voltage Operation. Connect
CP to IN when the input voltage is in the 5.5V to 11V range.
3
CN
Negative Terminal of the Charge-Pump Flying Capacitor for 2.7V to 5.5V Supply Voltage Operation. Leave CN
unconnected when the input voltage is in the 5.5V to 11V range.
Input Supply Voltage. IN powers all blocks of the MAX15031 except the switch driver and charge pump.
4
IN
Bypass IN to PGND with a ceramic capacitor of 1μF minimum value.
5
SGND
Signal Ground. Connect directly to the local ground plane. Connect SGND to PGND at a single point, typically
near the return terminal of the output capacitor.
Feedback Regulation Input. Connect FB to the center tap of a resistive voltage-divider from the output (V_OUT)
6
FB
to SGND to set the output voltage. The FB voltage regulates to 1.245V (typ) when V_CNTRL is above 1.5V (typ)
and to V_CNTRL voltage when V_CNTRL is below 1.245V (typ).
Control Input for Boost Converter Output-Voltage Programmability. Allows the feedback set-point voltage to be
7
CNTRL set externally by CNTRL when VCNTRL is less than 1.245V. Pull CNTRL above 1.5V (typ) to use the internal
1.245V (typ) feedback set-point voltage.
8
ILIM Open-Drain Current-Limit Indicator. ILIM asserts low when the APD current limit has been exceeded.
9
RLIM
Current-Limit Resistor Connection. Connect a resistor from RLIM to SGND to program the APD current-limit
threshold.
10
MOUT Current-Monitor Output. MOUT sources a current 1/10th of I_APD.
11
CLAMP Clamp Voltage Input. CLAMP is the external potential used for voltage clamping of MOUT.
12
APD Reference Current Output. APD provides the source current to the cathode of the photodiode.
Bias Voltage Input. Connect BIAS to the boost converter output (V_OUT) either directly or through a lowpass
13
BIAS filter for ripple attenuation. BIAS provides the voltage bias for the current monitor and is the current source for
APD.
Active-Low Shutdown Control Input. Apply a logic-low voltage to SHDN to shut down the device and reduce
14
SHDN the supply current to 2μA (max). Connect SHDN to IN for normal operation. Ensure that VSHDN is not greater
than the input voltage, V_IN.
15
PGND
Power Ground. Connect the negative terminals of the input and output capacitors to PGND. Connect PGND
externally to SGND at a single point, typically at the return terminal of the output capacitor.
16
LX
Drain of Internal 80V n-Channel DMOS. Connect inductor and diode to LX. Minimize the trace area at LX to
reduce switching noise emission.
—
EP
Exposed Pad. Connect EP to a large contiguous copper plane at SGND potential to improve thermal
dissipation. Do not use as the main SGND connection.
_______________________________________________________________________________________ 9