MAX312L_08 Datasheet, PDF (8/14 Pages) Maxim Integrated Products – 10Ω, Quad, SPST, +3V Logic-Compatible Analog Switches

10Ω, Quad, SPST, +3V Logic-Compatible
Analog Switches
Pin Descriptions (continued)
PIN (TQFN)
MAX312L MAX313L MAX314L
NAME
FUNCTION
7, 9, 17, 19 7, 9, 17, 19 7, 9, 17, 19
IN4, IN3,
IN2, IN1
Logic Inputs
6, 10, 16, 20
6, 10, 16, 20
6, 10, 16, 20
COM4, COM3,
COM2, COM1
Analog Signal Common Terminals
1, 5, 11, 15
—
—
NC1, NC4,
NC3, NC2
Analog Signal Normally Closed Terminals
—
1, 5, 11, 15
—
NO1, NO4,
NO3, NO2
Analog Signal Normally Open Terminals
—
—
1, 5
NO1, NO4 Analog Signal Normally Open Terminals
—
—
11, 15
NC3, NC2 Analog Signal Normally Closed Terminals
2
2
2
V-
Negative Analog Supply Input (connect to GND for single-supply
operation)
4
4
4
GND
Ground
3, 8, 12, 13, 3, 8, 12, 13, 3, 8, 12, 13,
18
18
18
N.C.
No Connection. Not internally connected.
14
14
14
—
—
—
V+
Positive Analog Supply Input
EP
Exposed Pad. Connect EP to V+.
Applications Information
Low-Distortion Audio
The MAX312L/MAX313L/MAX314L, having very low R_ON
and very low R_ON variation with signal amplitude, are
well suited for low-distortion audio applications. The
Typical Operating Characteristics show Total Harmonic
Distortion (THD) vs. Frequency graphs for several signal
amplitudes and impedances. Higher source and load
impedances improve THD, but reduce off-isolation.
Off-Isolation at High Frequencies
In 50Ω systems, the high-frequency on-response of
these parts extends from DC to above 100MHz with a
typical loss of -2dB. When the switch is turned off, how-
ever, it behaves like a capacitor, and off-isolation
decreases with increasing frequency. (Above 300MHz,
the switch actually passes more signal turned off than
turned on.) This effect is more pronounced with higher
source-and-load impedances.
Above 5MHz, circuit board layout becomes critical, and
it becomes difficult to characterize the response of the
switch independent of the circuit. The graphs shown in
the Typical Operating Characteristics were taken using a
50Ω source and load connected with BNC connectors.
Power-Supply Sequencing-Free
Operation
Most CMOS switches require specific power-supply
sequencing in order to prevent the devices from latching
up. The older MAX312/MAX313/MAX314 devices require
a proper power-supply sequence of V+, V_L, V-, and so
forth. Otherwise, it becomes necessary to add signal
diodes to the circuit in order to protect it from potential
latchups. The new MAX312L/MAX313L/MAX314L
devices eliminate the need for a V_L pin and permit the
user to utilize any power-up sequence that is required. It
is, however, important not to exceed the absolute maxi-
mum ratings because stresses beyond the listed ratings
may cause permanent damage to the devices.
TRANSISTOR COUNT: 92
PROCESS: CMOS
Chip Information
8 _______________________________________________________________________________________